Sauder 423399 Instruction Booklet

06/24/19 Purchased: __________________ English pg 1-14 Français pg 15-17 Español pg 18-20 NOTE: THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE. Share your journey! 5-Shelf Bookcase Model 423399 Visit sauder.com/service to order replacement parts, view video assembly tips, or chat with ...

Assembly Tools Required 2 3 4-14 15-17 18-20 21-22 23 Hardware Identifi cation Part Identifi cation Assembly Steps Français Español Safety Warranty Hammer Not actual size No. 2 Phillips Screwdriver Tip Shown Actual Size Page 2 www.sauder.com 423399 Hardware Identifi cation å Screws are shown actual size. You may receive extra hardwar ...

å While not all parts are labeled, some of the parts will have a label or an inked letter on the edge to help distinguish similar parts from each other. Use this part identifi cation to help identify similar parts. A UPPER RIGHT END (1) B UPPER LEFT END (1) C LOWER RIGHT END (1) D LOWER LEFT END (1) E TOP (1) F BOTTOM (1) G SHELF (1) ...

video assembly tip is available at www.sauder.com/services/tips å Assemble your unit on a carpeted fl oor or on the empty carton to avoid scratching your unit or the fl oor. å Push forty-six HIDDEN CAMS (1) into the ENDS (A, B, C, and D), TOP (E), BOTTOM (F), SHELF (G), and ADJUSTABLE SHELVES (H). Arrow 1 1 Arrow 1 ...

and D), SHELF (G), SHELF MOLDINGS (J and L), VALANCE (K), BASE (M), and END MOLDINGS (N and O). Page 5 www.sauder.com 423399 2 K L M N O J J J N O B A D C G ...

four HIDDEN CAMS. Step 3 Page 6 www.sauder.com 423399 1 2 E B A Surface with HIDDEN CAMS Surface with HIDDEN CAMS Surface without HIDDEN CAMS Edge with HIDDEN CAMS Edge with HIDDEN CAMS Do not stand the unit upright without the BACK fastened. The unit may collapse. Caution ...

four SILVER 1-1/2" FLAT HEAD SCREWS (11). Page 7 www.sauder.com 423399 SILVER 1-1/2" FLAT HEAD SCREW (4 used in this step) 11 B A G Edge with HIDDEN CAMS Surface with HIDDEN CAMS ...

BOTTOM (F). Tighten four HIDDEN CAMS. å Then, fasten the LOWER ENDS (C and D) to the SHELF (G). Tighten four HIDDEN CAMS. Step 5 Page 8 www.sauder.com 423399 F D C D C G Surface with HIDDEN CAMS Surface with HIDDEN CAMS Surface without HIDDEN CAMS Edge with HIDDEN CAMS Edge with HIDDEN CAMS Just think. ...

your unit. å Make equal margins along all four edges of the SMALL BACK (Q). Push on opposite corners of your unit if needed to make it "square". å Fasten the bottom and side edges of the SMALL BACK (Q) to your unit using the NAILS (10). å NOTE: Do not f ...

å Fasten the VALANCE (K) to the TOP (E) and UPPER ENDS (A and B). Tighten fi ve HIDDEN CAMS. å Fasten the UPPER END MOLDINGS (N) to the UPPER ENDS (A and B). Tighten six HIDDEN CAMS. E B A K N N These surfaces should be even. ...