PAX S300 Manual 

Pearl River, NY 10965 1-800-PC-AMERICA, 1-800-722-6374 (Voice) 845-920-0800 (Fax) 845-920-0880 1 | P a g e PAX S300 EMV Certified PINpad with Heartland Payment Processing pcAmerica now supports payment processing with EMV chip enabled cards through the PAX S300 EMV PINpad device. This document provides step-by-ste ...

Table of Contents  Installing the Hardware for standalone TCP/IP  Location of the built-in Stylus  Installing the Hardware for TCP/IP and Serial connections  Installing the Hardware for TCP/IP and Serial with the C2G USB adapter  Installing and configuring the C2G USB adapter and driver  Configuring the Communications Port for s ...

Installing the PAX hardware connections (3 configuration options supported) Important: Every register processing card transactions MUST have its own PAX unit. Also, settlements need to be run through CRE on each register a PAX unit is connected and processing card transactions. Standalone TCP/IP connection 1. Remove the back cover from the PINpad ...

3. Here is what the connection should look like. 4. Locate the included DC power adapter. 5. Connect one end to your outlet/surge protector and connect the other end to the data/power cable. ...

6. Connect an Ethernet cable (with internet) to the port on the data/power cable that says “LAN”. (The other 2 connections are not used.) 7. This is what your set up should look like when everything is properly connected. 8. Replace the back cover making sure to properly align the cable grommet into the channel. ...

Location of the built-in stylus The stylus can be found inserted horizontally on the top right of the PAX. ...

TCP/IP connection and 9-pin serial connection (COM1 or COM2 only) 1. Locate the cable with a 9-hole serial connector and an RJ-11 connector that was included with the PAX device. 2. Attach the RJ-11 connector to the COM1 RS232 port. If you have an interface cable with colored tips it is the BLUE connector, otherwise attach it to the RS232 port th ...

TCP/IP connection and 9-pin serial connection with C2G Serial to USB adapter 1. Locate the Cables to Go serial to USB adapter; Model: 26886; UPC-A: 757120268864. 2. Connect the 9-pin adapter to the 9-hole adapter on the Serial cable. 3. This is what your set up should look like when everything is properly connected. Make sure to install the PL230 ...

Download the serial to USB adapter from the link below: http://download2.pcamerica.com/drivers/Pinpad/PAX/PL2303_Prolific_DriverInstaller_v10518.z ip 1. Right-click on the PL2303_Prolific_DriverInstalle r_v10518.zip file you downloaded and select the option to Extract All…. 2. Click on Extract. 3. Right click on the PL2303_Prolific_DriverInstal ...

4. Click on Next. 5. Click on Finish. 6. In Windows Explorer, right- click on This PC and select Manage. (On older versions of Windows it may be called Computer or My Computer.) ...