Husqvarna 550iBTX Workshop Manual

1.2 Target group...........................................................3 1.3 Revisions................................................................3 1.4 Safety.....................................................................3 1.5 Servicing tools......... ...

This manual gives a full description of how to do maintenance and repair on the product. It also gives safety instructions that the personnel must obey. 1.2 Target group This manual is for personnel with a general knowledge of how to do repair and do servicing. All personnel that do repair or do servicing on the produc ...

Warnings, cautions and notes are used to point out specially important parts of the manual. WARNING: Used if there is a risk of injury or death for the operator or bystanders if the instructions in the manual are not obeyed. CAUTION: Used if there is a risk of damage to the product, other materials or the adjacent area if the ...

3.1 Servicing data (x3) 1.9 Nm (x1) 1.9 Nm (x1) 4.6 Nm T27 T27 T27 761 - 002 - 18.11.2019 Servicing data - 5 ...

(x2) 1.9 Nm (x2) 1.9 Nm (x1) 1.9 Nm (x6) 1.9 Nm (x4) 1.9 Nm (x7) 1.9 Nm (x1) 1.9 Nm T27 T27 T27 T27 T27 T27 T27 T27 6 - Servicing data 761 - 002 - 18.11.2019 ...

4.1 Servicing tools CST INSTRUCTION 3 2 1 4 Pos. Description Used for Order No. 1 Diagnostic Tool Kit Diagnostic examination and troubleshooting 583 89 71-01 2 Adapter cable for battery prod- ucts Diagnostic examination of bat- tery products with Engine Diag- nostic Tool - AutoTune™ (576 69 23-01) 581 19 23-01 3 T-handle Torx T27 Torx scr ...

part. 1. Remove the screw (A) to tilt the harness (B). A B C 2. Use tweezers to remove the servicing cable (C). 3. Connect the product to the backpack battery. 4. Push the start button on the backpack battery. 5. Make sure that the adapter cable for the common service tool (CST) is not connected to the p ...

5.1 To assemble the tube and handle on the product 1. Put the clamp (B) on the flexible tube (C) and attach the flexible tube to the blower outlet (A). A B C D 2. Make sure to put the clamp screw (D) as the illustration shows. Tighten the screw. 3. Attach the transport strap (O) to the guide track of the joint swivel (H). H O 4. Put the ...