Future Desion Controls FDC-VR18 Quick Start Manual

1 P.O. Box 1196 / Bridgeview, IL 60455 888.751.5444 / 888.307.8014 fax Technical Support: 866.342.5332 http://www.futuredesigncontrls.com Replacement of VR18 IC’s: Disk-on-Chip and Boot ROM A. Procedure of removing the old ICs 1. Turn off the power, take off communication cords, and take out I/O cards in rear Slo ...

2 P.O. Box 1196 / Bridgeview, IL 60455 888.751.5444 / 888.307.8014 fax Technical Support: 866.342.5332 http://www.futuredesigncontrls.com 6. Remove Disk-On-Chip and BOOT ROM carefully to avoid damaging any pins of ICs. Tools are available to pull out IC’s. It takes great care and proper tool pulling IC upward and ...

3 P.O. Box 1196 / Bridgeview, IL 60455 888.751.5444 / 888.307.8014 fax Technical Support: 866.342.5332 http://www.futuredesigncontrls.com B. Procedure of installing the new ICs 1. Before inserting the new Disk-On-Chip, check whether its pins are in proper condition. 2. Disk-on-Chip Install: Take note that the mark ...

4 P.O. Box 1196 / Bridgeview, IL 60455 888.751.5444 / 888.307.8014 fax Technical Support: 866.342.5332 http://www.futuredesigncontrls.com 4. Turn the main board upside down and put it back to the original place. Beware the stopper of CF reader at the front end of the board must go through the hole of the front bezel ...

5 P.O. Box 1196 / Bridgeview, IL 60455 888.751.5444 / 888.307.8014 fax Technical Support: 866.342.5332 http://www.futuredesigncontrls.com 7. Pull two ends of CN1 socket toward the display, and a little bit upward (not too much upward to avoid from breaking it), then insert CN1 cable in. Then, push two ends down and ...