Harrington Signal HS-3100 Programming Manual

Text of the manual

Fire Alarm Control Unit

Programming Manual Revision 1 January 2009 Document # LT-2001HAR HARRINGTON FIRE ALARM SIGNAL INC.

HS-3100/3200 Programming Manual

i Table of Contents 1.0 Operation and Programming Concepts ......................................................................... 1 1.1 Introduction ................................................................................................................... 1 1.2 General Information ..................................

HS-3100/3200 Programming Manual

iii List of Figures & Tables Figure 1: Four Wire Device Wiring (Typical) ....................................................................... 5 Figure 2: Network Plus System Window ............................................................................. 7 Figure 3: Switches Window ......................................

HS-3100/3200 Programming Manual

1 1.0 Operation and Programming Concepts 1.1 Introduction This chapter provides an overview of the HS-3100/3200’s (hereafter called the HS-3200) features and supported devices. 1.2 General Information Warnings: Before Programming 1. All applicable codes and standards should be considered when programming the Control Unit. 2.

HS-3100/3200 Programming Manual

2 1.3 Addressable Devices Supported Devices The HS-3030 can use analog/addressable devices. There are two general types of devices: sensors and modules. The following devices are supported: The M500S control module can be used to control a supervised output, such as a bell or strobe circuit. The control module monitors the cir

HS-3100/3200 Programming Manual

3 circuit is shorted. Also there are options in NP that affect the M500S control module but not the M500R relay module. The M500R relay provides two Form C relays. Choose “Control (relay)” for the M500R module. There are options in NP that affect the M500R relay module that do not affect the M500S control module. The M500X

HS-3100/3200 Programming Manual

4 Device Faults The following troubles (with condition code letter) can be reported by or for addressable devices: • Missing (M): A device listed in the database is not reporting back when polled by the panel. For a new installation, this is generally indicative of devices that have been mis- addressed. This error can also o

Other Control Unit Manuals