Digi One SP Manual 

Using the Digi One SP to Network Doppler Systems DDF6001s using an Ethernet A Technical Application Note from Doppler Systems Inc. Introduction The Digi One SP allows a device with a serial port to be connected to an Ethernet. This application note describes the connections and setup required to use the Digi One SP with the Doppler DDF6001 ...

set the serial port parameters to Baud Rate 2400, Data bits 8, Parity None, Stop Bits 1, and Flow Control None. Press Next and verify the settings you’ve entered and then press Next again and wait for the Digi One SP to reboot (takes about 1 minute). If you want to modify any ...