NET CPE5450 Quick Start Manual
Text of the manual
1.Preparation for installation:
1-0 Shake the devices (CPE5450) separately, to check if the device is damaged from
shipment, if you can hear some noise from inside of the device, and you suspect it maybe
PCBA board loosened, please contact us, we will help check if you need a replacement.
1-1 Move front cover
1-1-1 Push and then pull the front cover out
1-
100 meters to 2 kilo meters
1-2Application case 1:
CPEs work with your router, to extend Wi-Fi signal, (e.g.from A building to B Building)
1-2-1 Ensure you know the CPE kit are ready for installation
This step is to verify wireless connection between both CPE5450 (both Master and Slave), to make sure they are
pre-configured and can talk each other, It also
Test equipment list:
CPE5450 1 pair (2PCS, Master and Slave)
Wi-Fi router /cabled router 1pcs
PC (Notebook) 1 set
Ethernet Cable 4pcs
POE Power Adapter 2pcs (Ethernet Cable Length:<60M, or 194ft)
1-2-1-1 Use Ethernet cable to connect POE port of power adapter to LAN port o
1-2-1-4 Use Ethernet cable to connect LAN port of CPE5450 Slave(2#) to PC
1-2-1-5 Set range between CPE5450 Master(1#) and CPE5450 Slave(2#) : 3 meters is recommended, without
obstacle between 2 CPEs
1-2-1-6 Turn on all equipment, especially check as below to see if 2 CPE5450 are turning on, wait for 1 minute
Light is on
Light is not on
1-2-1-7 Light inf
1-2-1-8 Ping IP address of the Wi-Fi router (some is:192.168.1.1 or 192.168.0.1) on the PC
You could find IP of router on label (normally located on bottom of the router), following example is for your
reference
Following is 192.168.1.1 , Win7 OS for example.
A. Click “Windows” icon
Flash
B. Input command “ping 192.168.1.1 –t”
C. Click “enter” to
Ping 192.168.1.1 –t
Following messages indicates the CPE5450 devices are working well.
1-2-2 The default password for the device is : 66666666
1-2-3 IP address for another CPE, M (Master) CPE5450 is: 192.168.188.252,
and IP address for S(Slave) CPE5450 is :192.168.188.253, so you could