Mopar 82212423AB Manual 

1 2 Wireless Ignition Module (WIN) 1 3 FOBIK 2 4 WIN Antenna 1 5 Hood Latch Assembly 1 6 Zip Ties 10 CAUTION: XBM remote start can ONLY be installed on vehicles that have the following factory options: Automatic Trans­ mission, Remote Keyless Entry and Immobilizer. WinFobik based vehicles, the sales code ...

1. Disconnect and isolate the negative battery cable. If equipped with an auxiliary battery, disconnect and isolate the auxiliary battery's negative cable as well. NOTE: Engine removed from graphic for clarity. 2. Remove the push pin retainers (2) and the upper ra­ diator seal/shroud (1). 3. Using a grease pencil or eq ...

bly (1). 7. Position the hood latch assembly (1) to the upper ra­ diator crossmember and loosely install the two bolts that secure the latch to the crossmember. 8. Align the hood latch assembly (1) to the upper radiator crossmember using the reference marks made during the removal procedure and tig ...

mounting bracket towards the inner left fender. Secure the hood switch harness (2) as necessary to the existing vehicle harness using the tie straps (1) included in the kit. 13. Remove the ground retainer (1) from the inner left fender (3). Jun 21, 2010 K6861080 4280312 ...

grated Power Module (3) (TIPM) B+ terminal. Remove the B+ cable (2) from the TIPM. 15. Using a suitable flat blade tool, disengage the TIPM upper retaining tabs from the battery tray bracket. 16. Grasp the TIPM (1) and rotate the assembly up to free it from its mounting bracket (3). Position the a ...

and secure where necessary. 19. Remove the “Secondary Lock” from the rear of the connector. 20. Remove the weather seal from the rear of the connec­ tor. 21. Remove the front portion of the connector from the connector housing. This portion of the connector aligns the terminals properly within t ...

connector housing's mating side. 23. Route the Purple/White wire (1) from the hood switch harness through the secondary lock, through the weather seal and into the terminal 3 (G70 circuit) slot of the connector housing's wiring side. 24. Reinstall the front portion of the connector, making sure tha ...

terminal of the TIPM (3). 29. From the top of the mounting bracket, press the switch downward into the mounting hole until the integral switch latch tabs lock it into place. 30. Install the ground from the pigtail harness (2), to the fender under the body ground (4). Jun 21, 2010 K6861080 4280312 ...

31. Install the push pin retainers (2) and the upper radiator seal/shroud (1). 32. Connect the negative battery cable. WIRELESS IGNITION MODULE (WIN) MODULE REMOVAL 1. Using a trim stick C­4755 or equivalent, disengage the retainer clip that secures the hood release to the steer­ ing column opening cover, a ...