National Instruments CB-27 Installation Manual

companies. 320933B-01 © Copyright 1995, 1998 National Instruments Corp. All rights reserved. October 1998 INSTALLATION GUIDE CB-27 CONNECTOR BLOCK This installation guide describes how to connect the CB-27 connector blo ...

2 © National Instruments Corporation Installation To connect the CB-27 to your DAQCard, perform the following steps: 1. Insert the DAQCard into the PCMCIA slot of your computer. 2. Plug the PR27-30F into the 27-pin connector on the DAQCard or the PSH32-30F cable into the 32-pin connector on the NI 4350 (PCMCIA). Caut ...

3 CB-27 Connector Block Installation Guide Figure 1. A Typical Configuration Signal Connection Note A blank quick-reference label that shows the screw terminals for DAQCards is shipped with your CB-27. You can fill in the blanks with the signal information from your DAQCard user manual and put the label on the inside of t ...

4 © National Instruments Corporation 3. Connect the wires to the screw terminals by stripping off 1/4 in. of the wire insulation and inserting the wires (26–18 AWG) into the screw terminals. Tighten the screws. 4. After you connect the wires to the screw terminals, attach the wires to the CB-27. Bunch the wires fro ...

5 CB-27 Connector Block Installation Guide Cable Removal To remove the PR27-30F or PSH32-30F I/O cable, perform the following steps: 1. Grasp the cable connector near the DAQCard and pull it straight out. (If you pull the cable out using a rocking motion or pull directly on the cable, you may damage the pins on the cable o ...