Numark NDX800 Setting Up

This guide will walks through setting up one or two Numark NDX800 Controllers and a DJ|iO USB audio interface with Traktor LE. Contents Install the Latest Software and DJ|iO Drivers......................................................................... 1 NDX800 and DJ|iO Hardware Setup ............ ...

3. Connect the NDX800 Controller(s) and DJ|iO to USB Ports on your computer. Power on the NDX800 Controller(s). 4. On the NDX800 hardware itself: • Set both the left and right decks (if you’re using two units) to USB-MIDI source mode. 1. Press SOURCE. 2. Rotate the PARAMATER knob until the screen reads <> USB-MIDI ...

Then click Next. 9. On the next page, set manufacturer to Numark. If you’re using two NDX800 Controllers, set model to NDX800 LE Dual Deck. If you’re using a single NDX800, set model to NDX800 LE Single Deck. Click Next. 10. On the next page, next to Are you using a ...

11. Next, to go into the Preferences menu in Traktor LE to configure the MIDI/Audio settings. • On Windows, go to File > Preferences. • On Macintosh, go to Traktor > Preferences. 12. Click on Audio Setup. • Make sure that Numark USB Audio Device is selected. 13. To set up your audio input and output configuration click on Output ...

14. Click on Controller Manager on the left-hand side of the preferences window. 15. Setup your first NDX800 to control Deck A in Traktor LE: 1. Next to Device, select NDX800 DeckA Controls. 2. Under In-Port, select USB Audio Device. 3. Under Out-Port, select USB Audio Device. 4. If you’re using a single NDX800, Next to ...