Nameek's New Space Series Installation Instructions

Text of the manual

Included Sink Installation Hardware

Vanity Installation Hardware Tools You May Need Following these mounting instructions with the hardware included will be more than sufficient to support vanity installation. Level Tape Measure Drill Hammer Ph

1. Prepare Location

Locate studs in the wall. If the studs do not line up with the holes in the back of the sink and vanity, be sure to add sufficient wall supports behind the finished wall. 2. Mount Vanity Brackets Mark the desired height of the vanity on the wall. Mark the location of the mounting brackets and bottom of the vanity. Drill pilot holes and in

3. Install Vanity

Base Hang vanity base on mounting brackets. Use a phillips head screwdriver for adjustments and tightening. 4. Attach Vanity Handles Use a phillips head screwdriver to attach handles to vanity doors and drawers.

5. Install Hanger

Bolts Measure the distance between mounting holes in the back of the sink. Drill pilot holes and screw in hanger bolts. Check the position with a level. 6. Mount Sink With Washers and Nuts Thread the sink on to the two hanger bolts. Secure the sink with insulation sleeves, washers and nuts. Be careful not to over tighten the bol

8. Vanity Accessories

Complete your installation by adding the preferred plumbing accessories, such as the faucet, click clack drain, p-trap and angle valves to your vanity. 7. Install Caulk Finish the sink installation with a bead of caulk between the sink and wall. 4

Other Indoor Furnishing Manuals