MORTEX E30 SERIES User's Information Manual

DOWNFLOW For Installation In: SINGLE AND TWO STAGE 1. Manufactured (Mobile) Home 2. Recreational Vehicle ELECTRIC FURNACE 3. Modular Homes & Buildings 4. Residential Homes MODELS: E30 SERIES LIST OF SECTIONS – USERS INFORMATION MANUAL 1 – General 1 4 – Start Up & Shutdown In ...

This is a safety alert symbol. When you see this symbol on labels or in manuals; be alert to the potential for personal injury. Understand and pay particular attention to the signal words DANGER, WARNING, or CAUTION. DANGER: indicates an imminently hazardous situation, which if not avo ...

conform to existing national standards and safety codes. In some instances these instructions exceed certain local codes and ordinances, especially those who have not kept up with changing mobile home, modular home and HUD construction practices. These ...

these responsibilities with the installer or service company so there no misunderstanding at a later time. While you are away The furnace is equipped with safety shutoff devices which will shut off the electric heaters in case of a malfunction. For t ...

indicate the location of the air filters if you have a louvered return air door. Figure 2: Return Air Louvered Door Air Filter Location Figure 3: Return Air Louvered Door 20” x 20” x 1” Air Filters Return Air Grille Air Filters Follow these ...

Location. Figure 5: “A” Coil Hanging Air Filter Location. NOTE: Coil Filters are used with the Frame and Grille assemblies only. Position filters over the coil as shown in Figure 5. Homeowners must be instructed as to how to clean and reinstall filt ...

SECTION I: SAFETY THE HOME OWNERS AND / OR APPLIANCE USERS MUST STOP HERE! This section has been designed to assist a qualified service agency in performing service and maintenance on this appliance. The homeowners and/or the appliance user must never attempt to perform any ...

The interior sections of the furnace must be cleaned and adjusted by a qualified service contractor once a year or before the start of each heating season. The following items must be checked: 1. The blower wheel and motor for excessive dirt. 2. The electric heaters for wea ...

using the screws that were removed in step 5. 16. Reinstall the control box cover and secure it to the control box with the screws that were removed in step 4. 17. Reinstall the lower access door on the furnace. 18. Reinstall the upper access door ...

terminal strip. This signal energizes the heater contactor(s) closing the contacts to the heaters. The blower heating speed wire is connected to the “W” terminal on the terminal block so the blower is energized at the after the ON delay has ex ...