Mocka Jesse Bedside Table Assembly Instructions Manual

Text of Mocka Jesse Bedside Table Assembly Instructions Manual

L + R

bolt locking nut dowel H I J 35 mm x8 small screw x1 allen key x4 x4 screw x4 Hardware Supplied *We recommend using a Flathead screwdriver to tighten all locking nuts 100% inserting the nut to ensure it locks 100% WARNING: Any furniture that is not anchored to a wall has the potential to tip over in certain circumstances, i.e. if a child attempts to climb up on the furniture or in the event of an earthquake. Accordingly,

To begin assembly, screw 4x bolts (A) and insert 4x wooden dowels

(B) into panel [1]. Next attach 2x rail components (D) to the inside of panels [3] & [4] using 2x screws (C) in each and the holes provided. A B B A A B B A A x4 1 4 C C D 3 C C D x4 C Jesse Bedside Table 2 mocka.co.nz | mocka.com.au Assembly Instructions

Slot panels [3] and [4] together with panel [1]. Place 4x locking nuts (E)

into holes in the vertical panels and tighten with a flathead screwdriver. Slide the back panel [5] down into place in the grooves of panel [3] and [4]. Insert 4x dowels (B) into the top of panel [3] and [4]. Attach the base panel [2] by inserting 4x long screws (H) and tighten with a screwdriver. Screw 8x bolts (A) into holes in the base panel [2]. E x4 4 E 3 E E 1 5 B A x8 H x

To assemble the base insert 4x bolts (A) and screw 4x cam bolts (G)

into pieces [6] & [7] using the allen key (J). Insert 2x cam nuts (F) into each support panel [9]. Connect all components together using 4x locking nuts (E). Tighten with a screwdriver. Attach the base and legs using 8x locking nuts (E). Tighten with a screwdriver. E x4 A A x4 6 7 9 9 E 8 6 7 8 7 6 E G G G F G E F F E F E E E G J E Jesse Bedside Table Assembly Instructions 4 mocka.co.n

mocka.co.nz | mocka.com.au

7 8 To assemble the drawer screw 4x bolt (A) into holes in the front panel [10]. Attach side panels [11] and [12] to the front panel by inserting 4x locking nuts (E) into holes in the side panels and tighten with a flathead screwdriver. Slide the base panel [13] into place in the grooves in side and front panels as shown. Drawer A x4 E x4 13 11 12 10 E E A A E A A 10 Drawer Jesse Bedside Tabl

Attach the back panel [14] into place between the side panels [11] and

[12] using 4x screws (I) in the holes provided with a screwdriver. Attach 2x rail components (D) to both left and right side of each drawer using 4x screws (C). x4 I I I I I 14 12 11 DL C C C C DR Drawer Drawer Jesse Bedside Table Assembly Instructions 6 mocka.co.nz | mocka.com.au

Mocka Indoor Furnishing Owners Instructions: