MAXSA 40330 Manual
Text of the manual
Whether you have one of our newer models with 12 LEDs
and just need to replace the batteries, or you have an older
model with 6 LEDs and need to replace the battery pack,
these instructions will guide you, step-by-step, through the
process.
If you have questions at any time, please don’t hesitate
to contact the MAXSA Innovations office for ass
Step 1: Loosen Faceplate
Remove the circled screws from the nuts.
Loosen the screws on the side of the
faceplate. There is one screw on each
side.
Step 2: Open Faceplate
Once the front screws have
been removed and the side
screws have been loosened,
rotate the faceplate forward
and down, exposing the
reflecting tray.
Step 3: Remove Reflective Plate
Pull the reflective plate out of
the light. It should lift right out
and expose the LED board. You
will see two screws holding the
LED board in place (circled in
red). Remove them.
Keep track of the bolts. You
will need to switch one with
one of the bolts later on.
