LuxaFlex PolySatin Quick Start Manual

Text of LuxaFlex PolySatin Quick Start Manual

The information and advice included in this brochure has been

prepared with care. However, we are unable to accept responsibility for the results of or any damage caused during operation. Luxaflex PolySatin® Shutters are made from a polyresin compound, so it is guaranteed to be water resistant and will not blister, peel, flake, corrode

Tilt bar operation

For shutters with a tilt bar, use the tilt bar to adjust the louvre closure. SmartView® operation For shutters with SmartView, gently grasp a louvre blade in the middle of the panel and move the louvre to the closed position. Run your hand over the louvres to close them completely. ClearView operation For shutters with ClearView

Do not grab the tilt bar or louvre to open out

a hinged or bi-fold on track shutter or to slide a sliding shutter as this may place too much pressure on the tilt bar and louvre fittings. Instead open the louvres, if necessary, and gently grasp the shutter panel frame. Care and cleaning PolySatin Shutters are made from a non-toxic polyresin com

• External shutters should be hosed down regularly

and washed with a mild soap solution to remove salt and air pollutants. Shutter hardware should be sprayed regularly with a silicon spray. IMPORTANT NOTE Never use harsh abrasives, chlorine-based cleaners and cleaners containing organic solvents on the shutters as they may affect the surface appearance an

LuxaFlex Indoor Furnishing Owners Instructions: