KEENCUT Evolution Bench Assembly Instructions Manual

Text of the manual

Inspired Design – Precision Engineering

ASSEMBLY INSTRUCTIONS Thank you for choosing the Keencut Evolution Bench. Every effort has been made to bring you a precision engineered product with the promise of many years of valuable service. In order to obtain maximum benefit from your machine please read these instructions carefully. For advice

You should have;

Beam A (Front to back) 4x125 6x125 6x125 8x125 8x125 Beam B (Side to side) 3x182 6x114 6x139 9x108 9x125 Leg 4 x 87 6 x 87 6 x 87 8 x 87 8 x 87 Bench Edge Extrusion 1x182 2x114 2x139 3x108 3x125 LH Bracket 1 1 1 1 1 Centre Bracket 0 1 1 2 2 RH Braket 1 1 1 1 1 Fixing Block 2 2 2 2 2 End Fixing Screws 4 4 4 4 4 Base Bracket S

Order of Assembly

3 The Order of assembly is important – the following diagrams are for quick reference only and are to enable the reader to familiarise themselves with the general assembly of the Evolution Bench, the detailed assembly is described in 4 stages. Stage 1 Fix the brackets to the legs. The 160 Evolution Bench has only 4 legs, please disregar

Put a grub screw backwards into each of the joining brackets – do not place screws in the

other holes. NOTE: The following instructions will assume the Evolution Bench has six legs. If you are constructing a 160 Evolution Bench please omit the middle frame.     ® 3.1 Assembly 3.1 a 2. Using the spacer, fit the brackets to the top of each le

Put grub screws in each of

the two large holes of the bracket, only screw them in 2 or 3 turns. 5. Fix the height adjusters into the bottom of each leg. Position the adjuster in one of the internal grooves of the leg (ie. the same groove the brackets are fitted). Position the bottom of the aluminium bracket level with the bottom of the le

Lay one of the Bench Edge Extrusions

flat side down on the floor together with the RH Bracket and the RH end frame as shown. 2. Push the tongue into the hollow in the Bench Edge Extrusion. 3. Push the Bench Edge Extrusion/RH Bracket onto the Joining Bracket on the End Frame. 4. Tighten both Grub screws ensuring there is no gap bet

Position three Beams B on the Joining

Brackets but do not tighten the bracket screws at this stage. 6. Align the Centre Frame as shown. Place the Centre Frame in the Centre Bracket and push the tongue into the hollow in the Bench Edge Extrusion. 7. Push the Bench Edge Extrusion onto the Joining Bracket on the Centre Frame. As all four Joi

Place the second Bench Edge Extrusion

into position and tighten both Screws 9. Position the remaining three Beams B on their Brackets but do not tighten the screws. If a 310 or a 360 bench is being constructed, repeat steps 6 to 8 to install the second centre frame. 10. Slide the tab on the LH Bracket into the Bench Edge Extrusion then fi

Now refer to your Evolution Instruction

Manual to fit the cutter onto the bench. Set the Table in its working position and use the Height Adjustable feet to get the table to within 3mm of flat (as explained in the Evolution Manual). Instead of using the woodscrews supplied with the Evolution use the Allen screws provided with the

Other Cutter Manuals