Extron electronics TLP 1000MV Operation & User’s Manual

User Guide TouchLink™ TouchLink Touchpanel Control Systems 68-1909-01 Rev. C 03 20 ...

WARNING: This symbol, , when used on the product, is intended to alert the user of the presence of uninsulated dangerous voltage within the product’s enclosure that may present a risk of electric shock. ATTENTION: This symbol, , when used on the product, is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipment. For information on safety g ...

Trademarks All trademarks mentioned in this guide are the properties of their respective owners. The following registered trademarks (®), registered service marks (SM), and trademarks (TM) are the property of RGB Systems, Inc. or Extron Electronics (see the current list of trademarks on the Terms of Use page at www.extron.com): Registered Trademarks (®) Cable Cubby, ControlScript, Cross ...

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. The Class A limits provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful i ...

Notifications In this user guide, the following are used: WARNING: Potential risk of severe injury or death. AVERTISSEMENT : Risque potentiel de blessure grave ou de mort. CAUTION: Risk of minor personal injury. ATTENTION : Risque de blessure mineure. ATTENTION: • Risk of property damage. • Risque de dommages matériels. NOTE: A note draws attention to important information. Software Commands Commands are written in th ...

Features...................................................................1 Requirements...........................................................3 Software..............................................................3 Hardware.............................................................3 Panel Features......... ...

and TLP 1000TV panels. Unless otherwise stated, the terms “TLP 1000 Series,” “TLP 1000,” “touchpanel,” and “TouchLink touchpanel” refer to both models. The guide also provides information about optional accessories that are available from Extron for both touchpanels. This section provides information about: • TLP 1000MV and TLP 1000TV ...

• Adjustable sleep timer puts touchpanel into sleep mode. • Motion detector wakes the touchpanel. • Light sensor adjusts screen brightness as ambient room lighting changes. Easy configuration and flexibility — using Extron software, on-screen graphics and text, as well as the functions associated with them, can be easily changed to adapt the control panel to the evolving needs of the system, avoiding the need for addition ...

the Extron web page for that software. NOTE: These touchpanels and controllers are not compatible with GUI Designer or Global Configurator Plus and Global Configurator Professional. Hardware An Extron IP Link control interface must also be connected to the same network domain as the TouchLink panel. See www.extron.com for a list of sui ...

• TLP 1000MV Front Panel Features • TLP 1000MV Rear Panel Features and Connections • TLP 1000TV Front Panel Features and Operations • TLP 1000TV Rear Panel Features and Connections TLP 1000MV Front Panel Features A B B C C D D E E F F D D Figure 2. TLP 1000MV Front Panel A Motion sensor — is capped with a small Fresnel lens that focuses light onto the sensor. When no motion has been detected for a user-de ...

A Light sensor — mounted on top of the display frame. The sensor monitors the level of ambient light and adjusts the screen brightness. The sensor can only be viewed from above the panel. Reset Buttons and LED There are two buttons and an LED recessed behind the faceplate. They can be accessed by removing the front bezel, using the Extron removal tool. A C C B B Figure 4. TLP 1000MV Front Panel with the Bezel Removed A ...

A C C B B D Figure 5. TLP 1000MV Rear Panel Features A MTP signal adjustment controls (see page 6) B MTP input (see page 6) C Network and Power over Ethernet connector (see page 7) D Power connector (see page 9) A MTP signal adjustment controls — three MTP signal adjustments are available for S-video luminance gain (VID/Y), S-video chrominance gain (C), and sharpness (S). For composite video signals, the g ...

TLP 1000MV connects to a network using a twisted pair cable, terminated with an RJ‑45 connector. The network port has two LEDs. The green LED lights solid to indicate that the touchpanel is connected correctly to a network. The yellow LED flashes to indicate that data is being passed to or from the touchpanel. An Extron IP Link control processor must also be connected to the s ...

building use only and are considered to be part of a Network Environment 0 per IEC TR62101. • Les écrans tactiles sont conçu pour une connexion à un circuit PoE pour une utilisation intérieure seulement et est considéré comme faisant partie d’un environnement réseau 0 par IEC TR62101. • Always use a power supply provided by or specified b ...

screw connector from the 12 VDC, 1.0 A power supply (not provided) to the power supply socket on the rear panel. Ensure the connections have the correct polarity as shown below. Power Receptacle DC Power Cord Captive Screw Connector SECTION A–A Ridges Smooth Power Supply Output Cord A A 3/16" (5 mm) Max. External Power Supply (12 VDC, 1.0 A max.) Ground all Devices Grou ...

power supply voids all regulatory compliance certification and may cause damage to the supply and the end product. • Utilisez toujours une source d’alimentation fournie ou recommandée par Extron. L’utilisation d’une source d’alimentation non autorisée annule toute conformité réglementaire et peut endommager la source d’alimentation ainsi qu ...

A B B C C D D D D E E F F Figure 8. TLP 1000TV Front Panel Features A Motion sensor — is capped with a small Fresnel lens that focuses light onto the sensor. When no motion has been detected for a user-defined period of time, the unit enters sleep mode. When motion is detected by the sensor, the screen display is restored and active. B Microphone — is located below the LCD screen. C Connection status L ...

The TLP 1000TV has a stand that allows it to be placed on a desktop. The stand can be removed to VESA mount the unit. Both the stand and the touchpanel have removable covers that conceal the rear panel features and protect cables that are attached to the TLP 1000TV. The rear and base covers can be removed using the Extron removal tool (see Removing the TLP 1000TV Base for VESA Mounting on page 47). D E E F F ...