DynaLock 1661 Instructions

2) Place template on inactive door so that CL mark aligns with CL of template and dotted vertical line of template aligns with vertical edge of inactive door. 3) Mark the mounting holes for the Double Door Housing (DDH) on the inactive door. 4) Drill two 13/32” (0.406”) holes through inactive door. 5) Drill wire access hole into desired area of DDH. Pull two (2) wires through the access hole and connect to strike. (Polarity is not observed) 6) Temporarily mount 1661 strike to DDH through the slotted holes (Hole C) using 1/2” button head socket cap screws. (BHSCS) 7) Mount DDH to inactive door using the two (2) 1/4-20x3” screws and 1/4-20” Sex Nuts supplied. 8) Adjust electric strike insert horizontally (If necessary), until Pullman Latch engages when door is closed. (See Fig. 4 on 0161 installation instructions if further horizontal insert adjustment is necessary) 9) Mark, drill and tap Hole D for 1/4-20x1” BHSCS provided to secure the final location. A 27/32 .844 21.43 B 3-1/2 3.500 88.90 C 1/4 0.250 6.35 MEASUREMENT FRACTIONAL INCHES DECIMAL INCHES METRIC (mm) 13/32” (0.406”) 13/32” (0.406”) CL c B B ©2005 DYNALOCK WWW.DYNALOCK.COM 705 EMMETT ST. P.O.BOX 2728 BRISTOL, CT 06011-2728 USA PHONE: 860-582-4761 FAX: 860-585-0338 EMAIL [email protected] 1661 DOUBLE DOOR HOUSING

Typical Double Door Housing Assembly Double Door Housing Typical Surface Exit Device 1661 DOUBLE DOOR HOUSING ACTIVE DOOR EDGE DEADLOCKING TRIGGER LATCH CL CL CL CL A B B DOOR FACE INACTIVE DOOR EDGE SCREW 1/4-20X3” POWER BLOCK DRILL 13/32” HOLE (2 PLACES) ACTIVE DOOR EDGE TYPICAL SURFACE EXIT DEVICE SEX NUT 1/4-20” HOLE C SCREW 1/4-20x1/2” HOLE D SCREW 1/4-20x1” HOLE D SCREW 1/4-20x1” HOLE C SCREW 1/4-20x1/2” INACTIVE DOOR NOTE: Not to scale. Specifications are subject to change without notice. ©2005 DYNALOCK WWW.DYNALOCK.COM 705 EMMETT ST. P.O.BOX 2728 BRISTOL, CT 06011-2728 USA PHONE: 860-582-4761 FAX: 860-585-0338 EMAIL [email protected]