laguna PL 12/20 Manual 

Irvine, California 92606 Ph: 800.234.1976 www.lagunatools.com © 2017, Laguna Tools, Inc. LAGUNA® and the LAGUNA Logo® are the registered trademarks of Laguna Tools, Inc. All rights reserved. ...

after-sales service and solutions, please keep this instruction booklet and other attachments for your use later. The Manual is going to show you the work principle, methods of installation, operation, troubleshooting, transport, storage and maintenance. If it’s your first time usi ...

check us out @ https://lagunatools.com/videos/laser-video-page for training and tech videos. 2. It is recommended that you never operate your laser with the protective cover open or bypassed. 3. Never expose yourself or anyone else to the invisible laser ...

The chiller has four components that need to be attached: 2 water Tubes, an alarm cable and power cable. 1. On the back of the chiller you will find 4 ports, the farthest port to the right will be for the power cable. You will connect the power cable here. 2. There is an “Alarm Output” port to the left of the power port. ...

The air compressor comes with one attachment, an air hose with a connector. 1. Attach the air hose to the compressor by screwing the connector into the compressor. 2. Run the air hose to the back of the laser cabinet and insert it to the “Air” valve. *note: it is recommended that you use a power strip with an on and off switc ...

The fan comes with two air tubes and an attachment for the back of the laser cabinet. 1. You will have a round black attachment with three screw holes. You will connect this to the back of the laser cabinet. Directly in the middle of the laser cabinet will be an exhaust port. Simply unscrew the screws that are in the adjoining loc ...

of the fan and the exhaust runs out of the side. You will connect one of the air tubes to the inlet port and connect it to the back of the laser cabinet. The tubes come with clamps that simply screw to tighten and hold the tubes in place. 3. You will attach the ...

ensure you are getting a good cut and that you are utilizing the full power of your laser. There are five parts to the laser path. Laser to rear mirror, rear mirror to gantry mirror, gantry to head mirror, head mirror to focus lens and focus lens to th ...

and user manuals. Click on the RDWorks software file and install it on the computer you will be working with. If you have any difficulties with this install. Go to https://lagunatools.com/design- software-resources and download current version of RDWorks. Once the ...

Specifications subject to change. Machines may be shown with optional accessories. © 2017, Laguna Tools, Inc. LAGUNA® and the LAGUNA Logo® are the registered trademarks of Laguna Tools, Inc. All rights reserved. 2072 Alton Parkway. Irvine, CA 92606 Ph: 800.234.1976 | www.lagunatools.com ...