Radio Shack 15-1915B Owner's Manual
Text of the manual
Cat. No. 15-1915B
OWNER’S MANUAL
Pocket Remote Control
Please read before using this equipment.
15-1915b.fm Page 1 Monday, July 19, 1999 12:06 PM
Need help? Call 1-800-950-7557
2
INTRODUCTION
Your RadioShack Pocket Remote Control can re-
place up to three standard infrared remote con-
trols.
Unlike some universal remote controls, the Pock-
et Remote is preprogrammed and does not have
to learn its commands from the original remote
controls. All you have to do is tell the Pocket Re-
mote which remote co
Need help? Call 1-800-950-7557
3
Note: You need two AAA batteries (not supplied)
to operate your Pocket Remote Control.
15-1915b.fm Page 3 Monday, July 19, 1999 12:06 PM
Need help? Call 1-800-950-7557
4
CONTENTS
How the Remote Works ......................................... 5
Setting Up the Remote ........................................... 6
Installing Batteries .............................................. 6
Setting Up Your Device Codes ........................... 7
Operation ..........................................
Need help? Call 1-800-950-7557
5
HOW THE REMOTE WORKS
After you set up the Pocket Remote, its command
keys work like the keys on your original remote
controls, though the labeling might differ slightly.
For example, a key on your original remote con-
trol labeled PWR ON/OFF is equivalent to the
Pocket Remote’s PWR key.
Notes:
• Use P to set up the Pocket
Need help? Call 1-800-950-7557
6
SETTING UP THE REMOTE
INSTALLING BATTERIES
Cautions:
• Be sure to have fresh batteries ready to
install before you remove the old batteries.
The Pocket Remote’s memory only lasts
about a minute without the batteries. If the
memory is lost, simply re-enter the 4-digit
manufacturers’ codes for your remote-con-
trolled dev
Need help? Call 1-800-950-7557
7
SETTING UP YOUR DEVICE
CODES
1. Refer to “Manufacturers’ Codes” on Page 11
and write down the codes for your original
remote controls on the provided label.
2. Press the device key for the type of remote
you are replacing (TV, VCR, or CBL). The red
light blinks.
3. Hold down P until the red light blinks twice,
then ente
Need help? Call 1-800-950-7557
8
• If the remote does not operate your device,
try other codes listed in “Manufacturers’
Codes” on Page 11 for your brand of TV,
VCR, or cable box. If your device still does
not respond, follow the steps outlined in “If
You Have Problems” on Page 31.
• The punch-through feature is automatically
turned on for the