Digitrax DT400 Manual 

DT400R throttle, the following two splash screens are displayed in sequence. The first splash screen displays the firmware ID and version. The second splash screen displays the battery voltage. When a DT400 or DT400R throttle is plugged into the LocoNet it displays either Ir” or Ra and the LocoNe ...

DT402D throttle, the following three splash screens are displayed in sequence. The first splash screen displays the firmware ID and version. The second splash screen displays the Duplex Group Name and Duplex Channel ID. The group name for our N-Trak layout is currently set to OKNRail and the channel is 26. The t ...

To turn track power on or off, first press the PWR button. The throttle message displays +On –Off. The Mode Indicator displays Pw. To turn track power on, press Y +. Note the track power indicator dot. If it is flashing, press Y + again to change it to on steady indicating track power on. To turn track power off, press N ...

The Mode Indicator displays FN. Throttle address shows flashing SEL (or previous loco #) indicating which side is active. Note: to switch sides turn knob on the other side. Press Loco button. Message window displays either stat 128 or Sel Loco. The Mode Indicator displays flashing Lo. Enter locomotive ID. Press Loco button ...

Note: this example shows use of right throttle to the left and left throttle to the right. Control speed with knob. The Mode Indicator displays FN. Power setting Arrow show direction (forward or reverse). Throttle address shows locomotive ID. Reverse button changes direction. Numbers indicate which functions are on. ...

Enter the lead locomotive ID on right side and the second locomotive ID on the left side. Ensure left smoke is flashing. Check direction arrows. (see below) Press MU button. Message briefly displays Consist. Message then alternates + = add and – remove. The Mode Indicator displays MU. Press Y + to add second loc ...

If any locomotives are consisted, they should be removed from the consist Left speed indicator shows CN. Ensure left smoke is flashing. Press MU button. Press N - to remove second locomotive from consist Ensure smoke is flashing on side to clear locomitive ID. Press LOCO button. Locomotive ID is flashing. Press EXIT butto ...

Enter the locomotive ID on the rotary address selectors. Press the SEL button or plug the throttle into the LocoNet. Check the status light. If it is blinking green the locomotive ID has been acquired. If taking locomotive control from another throttle, press the STEAL button. Locomotive Operation (UT4D) Control direction with the three ...

consist (speed and direction controlled by another loco ID) D Duplex Duplex (two way) radio allows all controls without being plugged into the LocoNet DISP Dispatch DT400/DT402/UT4D button to release control of locomotive ID Identifier A number (0-9983) which identifies a locomotive de ...