Yealink T4 series Registering And Using

1 Registering and using the Yealink T4- series, T2-series and T19P SIP phones on the Cloud PBX Table of Contents UC license required ............................................................................................................................. 2 List of Yealink ph ...

2 UC license required For system phone functionality, as described in this manual, a Unified Communications package license is required for the PBX. Only one SIP phone may be connected at each licensed extension. List of Yealink phones that are tightly integrated Yealink T19P / ...

3 Enable SIP notification messages Go to Features/Remote Control and enable SIP Notify as shown here: ...

4 Enter the registration details for the Cloud service Go to the Register page, under the Account tab, and enter the SIP registration details: Server Host, Register Name, User name and Password. These registration details can be obtained from the cloud PBX administrator. The Reg ...

5 Allow the Cloud PBX communicate using xml messages On the cloud PBX installer portal, go to System Settings/CTI Services and set the xHTML API to Enabled as shown below. At System Settings/Firewall, make sure the xHTML API is set to Unrestricted: ...

6 Program the soft keys on the phone with PBX functions The PBX menus can be accesses by pressing the PBX softkey. The Menu softkey gives access to local phone parameters such as the IP address. Go to your user portal on the cloud PBX, by browsing to your cloud server, normally ...

7 Note that the top button on the left of display corresponds with keys 1, 10 and 19, depending on the page selected by the Shift key on the phone. On the T48G/T49G, it’s most convenient to program the most frequently used keys to the outer key positions. Program the keys on t ...

8 User button LED modes The User buttons are implemented as SIP BLF keys. Yealink LED mode 1 is the only mode supported by the cloud PBX. When a key is assigned to monitor an extension, the behaviour of the LEDs is as follows: LED unlit: extension is idle LED f ...

9 Fault finding  Phone not registering: check the server address of the PBX and the user name and password.  Function keys not working or Load error on pressing the PBX key: The xHTML API on the PBX System Settings/CTI Services page must be enabled and the PBX Firewall mus ...

10 Appendices, dialling codes Default Numbering Plan 101 – 300 User Extensions 6900 – 6909 Meet-Me Conferences Rooms 7000 – 7299 300 Auto Attendants 800 – 819 20 Groups 820 – 869 50 Skill-Sets 9 Line access 0 Operator Group Explanation of the symbols used in the dialli ...