YardCraft Pluto Vinyl Playset Assembly Manual

One 4' Step Ladder Cordless Drill & 1/2" drill bit & 5/16" drill bit 25’ Tape Measure Pluto Vinyl Playset Assembly Manual Thank you for your purchase of this playset. This manual is designed to simplify the assembly process, however we recommend having an experienced carpenter involved in the project. Please read through the entire m ...

Unpack and identify parts. Begin assembly by placing four 2x6x56" in a square. Place four corner braces at each corner. Holes on 2x6's and corner brackets are offset. A good pattern to use is left-low, right-high. This pattern should be used in the entire framing process. Place tower 4x4 in corner. Alight pre-drilled hol ...

on the bracket. You will be able to tap on the acorn nut after the bolt has started coming through the bracket. Doing so prior may damage the threads on the bolt. Place washer and acorn nut on bolt. Only finger tighten at this point. Repeat steps 3-7 on the remaining three corners, then measure acros ...

end wrench. Keep in mind that over-tightening can damage the acorn nut. This is how your set should look at this point. Repeat steps 4-7 to assemble the "floor ring." Tighten all bolts using 9/16" deep socket and 9/16" open end wrench. Again, keep in mind that over-tightening can damage the acorn nut ...

Using the template provided, fasten joist hangers at proper positions. Fasten white metal joist hanger using 1 3/4" stainless steel washer head screw provided. Template will show amount of joist hangers that should be used. Install joists as shown. Top of joist should be flush with top of 2x6. Note: t ...

Repeat steps 4-7 to assemble the "top ring." Tighten all bolts using 9/16" deep socket and 9/16" open end wrench. Again, keep in mind that over-tightening can damage acorn nut. Complete main structure assembly by fastening "lips" of corner braces to 2x6's using 1 3/4" washer head screws provided. Each bracke ...

Be sure top of ladder is flush with top of floor. Attach using four 1 1/2" screws provided. Spacing between slats for slide should be 25 3/4". Same spacing should be used for rockwall. Fasten slide to floor using three 1 3/4" screws provided. Be sure screws are going through the decking and into the ...

Note: The positions of the slide and step ladder are interchangeable and can be placed anywhere on the tower according to your preference. This is simply done by removing slats wherever needed. Fasten sandbox seats to "sandbox ring" using 1 1/2" screws provided. They can be positioned at any corner, accordin ...