Xantech HDMI4X4 Operation & User’s Manual

2 Panel Layouts 3 Operational Instructions 4 IR Remote Control Installation 5 EDID Confi guration Guide 6 EDID Modes 7 Resolving IR confl icts 8 RS-232 Control Interface 9 Rack Mount Diagram 10 Specifi cations ...

1080p plus multichannel digital audio from any of the four HDMI™ sources to the displays. Four outputs gives you the choice of sending high defi nition audio and video signals up to four displays. Any four sources to any four dislay devices matrix switching allows for maximum versatility for integrated systems. The 4X4 HDMI Switcher eliminates the need to disconnect and ...

• The 4X4 HDMI Matrix works with all DVI and HDMI displays. • The 4X4 HDMI Matrix supports both AUDIO and VIDEO signals. • The 4X4 HDMI Matrix is fully HDCP compliant. • PLEASE READ THESE NOTES BEFORE INSTALLING OR OPERATING THE HDMI4X4 MATRIX SWITCHER Connect all HDMI/DVI input sources to the HDMI input jacks on the 4X4 HDMI Matrix, using supplied cables (a DVI s ...

1. Verify that DIP switches 1 & 2 are in the down (OFF) position. 2. Insert the battery; hold the battery so that you can see the positive 3. side facing up. The side that is not marked must be facing down. Test the RMT16-IR remote by pressing ONLY one button at a time. 4. The indicator light on the remote will fl ash once each time you press a button. WARNING: Do not pre ...

Extended display identifi cation data (EDID) is a data structure provided by a display to describe its capabilities to any source that asks for it. The EDID includes manufacturer name, product type, timings supported by the display, display size, luminance data, (for digital displays only) pixel mapping data, supported audio channels and formats. This information is used by the source to cater its output to r ...

EDID Mode 0 (Switch 1=OFF Switch2=OFF Switch5=ON) -EDID is copied from the device connected to the fi rst active HDMI output port. - All features newer than HDMI 1.2 are cleared. EDID Mode 1 (Switch 1=ON Switch2=OFF Switch5=ON) -Same as Mode 0 and adds basic audio support. EDID Mode 2 (Switch 1=OFF Switch2=ON Switch5=ON) -Same as Mode 0 and adds full audio support. EDID Mode 3 (Switch 1=ON Switch2=ON Switc ...

Remove the battery cover from the back of the RMT16-IR remote. 1. Locate the DIP Switches above the batteries. 2. Switch the DIP Switches on the RMT16-IR to any of the combina- 3. tions pictured below. DIP Switches 1 and 2 in the RMT16-IR infrared remote correspond 4. with DIP Switches 3 and 4 inside the 4X4 HDMI Matrix respectively. Switch the DIP switches inside the 4X4 HDMI Matrix to match the sam ...

19200 Data bits 8 Parity None Stop bits 1 Flow Control None RS-232 INTERFACE -8- ...

1.65 Gbps Input Video Signal 1.2 volts p-p Input DDC Signal 5 volts p-p (TTL) Single Link Range 1080p / 1920 x 1200 HDMI Input/Output Connector Type A 19-pin Female Remote Control Port RS-232 Female, Mini-Stereo Power Consumption 60 watts (max) Power Supply 24V DC Dimensions 17” W x 1.75” H x 5.875” D Shipping Weight 10 lbs. HDMI4X4 User Manual © 2007 Xantech Corporation This document is copyright protected. No part of th ...