WolfVision VZ-9 Instructions Manual
Text of the manual
Ethernet / LAN - Software 1.2
Ethernet / LAN - Software 1.2
for Visualizers:
VZ-9, VZ-9plus
VZ-27plus, VZ-27plus², VZ-57plus
VZ-C11, VZ-C12, VZ-C12², VZ-C30, VZ-C32
Check out our Internet Homepage for additional information
www.wolfvision.com/support
ENGLISH / DEUTSCH
R
all-guides
com
Printed in Austria, November 2006
Design and specifications are subject to change !
1
IBM-compatible PC
Image transfer / Visualizer control via Browser and WolfVision Ethernet/LAN software are supported.
System Requirements (recommended minimum)
-
Microsoft Windows 98, ME, NT 4.0, 2000 or XP (95 and NT 4.0 Terminal Server are not supported)
-
Pentium II 500
Ethernet cross cable
Host
PREVIEW
USB
LAN
2
Connecting the Visualizer to a computer / network
There are two methods to establish a LAN connection between the Visualizer and a computer or
network:
Method 1: Direct connection using a cross-over cable
If you want to connect the Visualizer to only one computer just connect the LAN-port (RJ-45) of
the Visualizer
Before the Visualizer can be accessed from the web browser of the computer, the IP-addresses
of both units must be set to IP-addresses which allow them to communicate with each other.
The easiest method is to set the Visualizer to automatically receive the settings for IP-address,
Subnet Mask and Gateway from a DHCP (Dynamic Host Configuration Protocol) serv
In order to access the built-in web server of the
Visualizer just open the standard web browser
on your PC and type the IP-address of the
Visualizer in the address field.
Then you will see the start page of the
Visualizer. If not please check the cable
connection or the IP-addresses of the
Visualizer and PC (see previous page).
Please note:
Even if the image
On Status information page, the current
state of the Visualizer can be checked.
Available information:
- Device Information like serial number,
Visualizer model, installed firmware
version
- Ethernet-settings like Mac-address, IP-
address, subnet mask and standard
gateway
- Operating hours
- Lamp status
- Power / Light settings
- Output re
Displaying live images
When the LIVE-link [LIVE] is clicked on the
start page, a live image from the Visualizer
is displayed. In addition the web browser
will also open a new window with a remote
control of the Visualizer.
Please note that JavaScript must be
enabled in order to see the live image.
Popups need to be enabled.
The frame rate of the live image i
When you receive your Visualizer the version of the Ethernet-software on the supplied CD-
ROM may be out of date. WolfVision constantly improves this software and adds important
new features to it.
Thus we highly recommend that you download the latest version of the WolfVision Ethernet-
software from the internet at
www.wolfvision.com/support
inst
During installation, maybe you are asked if you want to
replace newer files on your computer by older ones, then
keep the newer ones.
1.9
Click "Next"-button to continue the installation.
IMPORTANT:
If older versions of the Ethernet-software were not de-
installed before you tried to install the Software version
1.2, an error message will appear.
D
Usage of Ethernet / LAN Software
In the browser window, the desired Visualizer can be
selected (all connected Visualizers are shown). When
more than one Ethernet connections are available, the
desired connection can be selected in the displayed
window.
With the discovery mode you can choose between local
network area (LAN) or Internet. With Internet selectio