Windsor Arbor 11112 Assembly/installation Instructions

Text of Windsor Arbor 11112 Assembly/installation Instructions

Assembly & installation Instructions

General Information: » Read through carefully before beginning assembly. » When assembling components, place on a clean, flat, non-abrasive surface to avoid scratches. » In the event of missing or defective parts, please call our customer service department directly at 1-877-258-6020 Tools required: » Cordless Drill with #2 phillips bit » Hammer » Tape Measure » Shovel » Post Hole Digger (recommend

Lay out one right post (part 2).

Starting at bottom, insert one top/ bottom rail (part 3) and four center rails (part 4). Slide three vertical rails (part 5) through center rails and into top/ bottom rail. Insert one top/bottom rail (part 3) into right post, sliding three vertical rails into top/bottom rail. Slide left post (part 1) over corresponding top/bottom and center rails. DO NOT screw arbor panel together. REPEAT steps 1-4 for the second arbor pan

With arbor panels lying down and

screw pilot holes of each arbor panel facing out, slide two arbor top rails (part 6) all the way through both routed holes at the top of each arbor panel. Note: 2” sq. holes should line up with 2” sq. holes in the top of the arbor panels. This will leave 7” of overhang on each side of the arbor. Insert five arbor top cross rails (part 8) into arbor top rails and arbor panel posts by carefully separating posts just e

Apply PVC glue to inner edges of the

four flat post caps (part 9) and place on top of each post. Glue four 4” ar- bor top end caps onto ends of each arbor top rail. Glue four overhead rail end caps onto ends of each overhead rail. Using 1½” kappet screws, insert screws through holes of two overhead rails (part 7). Fasten screws to screw pilot holes of the five arbor top cross rails. Snap kappet screw caps over screw heads. 8 9

Slide one 24” steel u-channel ground anchor

into bottom of each post. Slide ground anchor until it meets bottom cross rail. For increased stability, unfasten bottom screws separate bottom of arbor panel just enough to slide ground anchor further into post. It is recommended to leave at least 16” of ground anchor exposed. Using 1” self- tapping white-head screw, fasten post to ground anchor. Using ground anchor installa

Windsor Arbor Outdoor Furnishing Owners Instructions: