ViziT KTM600F Operating Instruction

premises and is able to control either electromagnetic or electromechanical lock. ontroller con eader and ontrol nit and may be used as part of doorphone as well as stand-alone system. C ...

ACCESS keys Entrance door unlocking by pressing the indoor EXIT button Guard mode can be enabled disabled with a GUARD or MASTER key All ACCESS keys are disabled in this mode Programmable unlocked state duration Light sound indication of operating modes MASTER key memorizing GUARD ACCESS keys memo ...

10) vizit-group.com 3 11 / 201 - MOUNTING LOCATION Reader RD-4F EXIT 300M button The Reader is mounted on a wall near the entrance door, or on a fixed door leaf, outside the entrance doorway. The button is mounted on a wall near the entrance door, inside the entrance doorway. may s Note. Any button with NO ...

VIZIT-KTM600F Electromagnetic lock VIZIT IMPORTANT. DO NOT use electromagnetic locks with resistance less than 20 Ohms, and not provided with a built-in degaussing module. Basic types of electric strikes, solenoid locks Fail-locked (Fail-secure) Note. VIZIT-KTM600F The RF controller allows operation with different types of ...

LOCK ML EL TIME 1S 7S IMPORTANT VIZIT In order to correctly set the lock control logic, unlocked time, and lock supply voltage, the KTM600M PCB has corresponding jumpers installed: The jumper determines the door lock control logic: - position – a strike / lock is released when voltage is switched off. - position – a ...

Wiring is recommended to be done using a cable copper conductors PVC PVC with with insulation and jacket (1) (2) (3). 2 1 3 Electromagnetic lock VIZIT Circuit Wire Maximum length, m Diameter, mm Cross-section, mm 2 0 2 . 0 5 . 0 5 . 0 8 . Power supply unit  Control Unit Reader  Power supply unit Button for exit Electromagnetic l ...

companies is given on VIZIT.EU ( . http://vizit.eu/eurounion/) Reader RD-4F is mounted either on a wall, or on a fixed door leaf Reader RD-4F mounting on a fixed door leaf ( ) two methods - Drill 2 holes (1) with diameter 5.5 mm - ...

0 The Control Unit may be mounted either on a wall, or a DIN-rail. - - (4) coming from the power supply unit, Reader RD-4F, EXIT300M button and lock. - Connect the ends to the C U ’s terminals 5 - S (6) on the C U ’s PCB (7) ontrol nit ( ) et jumpers ontrol nit according to the table : U C U ’s cover (2) nfasten two screws (1) and ...

RF Controller with electromagnetic lock VIZIT-ML240-40 VIZIT-KTM600F -DL +DL BIP +E RD GND RG Reader RD-4F Black White Blue Red Green Button М EXIT 300 Black White Blue Red -DL +DL Electromagnetic lock VIZIT-ML240-40 +DL -DL +E OP RG RG RG +E RD RD BIP BIP OP OP -12 -18 +12 +18 +E GND BPD Power upply s unit 18/12-1-1 Q1 ML Q2 TIM ...

MEMORY “Key No…- User” MASTER-key memorizing PRG PRG N ACCESS keys memorizing N GUARD keys memorizing N ACCESS and GUARD keys erasing 1 “Key No…- User” N 2 ’S ote. ote. ote. Note . ote . keys the installation C U R 300M (or button for exit) T are and Lost key erasing U memorizes 2680 , 28 , appro ...