virtual access GW7000 Series Installing Instruction

1 Location variants ..................................................................................... 3 2 Installing a GW7000 Series router in the UK ........................................... 4 2.1 Package contents for the UK .................................................................. 4 2.2 GW7000 Series serial and model descri ...

1 Location variants There are cable variations for the GW7000 Series router depending on whether you have bought your router for use in the UK or outside the UK. If you are a UK customer, read section 2, ‘Installing a GW7000 Series router in the UK’. If you are a customer outside the UK, read section 4, ‘Installing a GW7000 Series ...

2 Installing a GW7000 Series router in the UK 2.1 Package contents for the UK If you are a UK customer, check that you have all the components listed below. Table 1: Components for installing your GW7000 1x GW7000 Series router 1x purple ADSL cable Both ends of the cable looks like this (RJ11): If your GW7000 Se ...

2.2 GW7000 Series serial and model descriptions for the UK When you receive your GW7000 package retain the outer packaging. The label containing the model number, serial number (S/N) and part number (P/N) is located on the side of the packaging box. Each GW7000 is assigned a unique serial number. Record your dev ...

Model Number Port Description Power Cable WAN Connection Cable RJ11 (purple) Modem (PSTN) Cable BT-RJ11 (black) Ethernet Cable (yellow) ADSL Filter GW7010 Quad Ethernet, WAN Ethernet Y Y - Y - GW7025 Quad Ethernet, WAN Ethernet Y Y Y Y - GW7110 Quad Ethernet, ADSL, WAN Ethernet Y Y - Y O GW7125 Quad Ethernet, AD ...

3 Installing a GW7000 Series router in the UK before it is automatically configured The GW7000 Series router is shipped in its factory default configuration for automatic configuration. After you have powered up the router for the first time, the config LED flashes to indica ...

The GW7000 Series router is shipped in its factory default configuration for automatic configuration. The config LED will be flashing to indicate that it is in a factory default configuration. The router automatically downloads its firmware and configuration files either via ...

3.3 Installing a GW7000 Series router with an E1/T1 connection in the UK Figure 4: The cables you need for an E1/T1 and power connection 1. For a standard connection, connect one end of the E1/T1 cable to the E1/T1 port on the back of the router and the other end of the cabl ...

Figure 5: The position of the SIM card 4. Attach the antenna to the GW7000 Series router. 5. Connect the power supply connector to the power port. The router initialises. The CONFIG LED flashes, and all the LEDs temporarily light in sequence. Then the router activates. The a ...