Tuffy 309 Installation Instructions

2003-2010 With Under Seat Metal Tray Page 1 2011-Current With Under Seat Plastic Tub Page 2 Please read and fill out the enclosed warranty registration card to activate your warranty. PARTS CHECKLIST LOCKBOX #309 Tools needed for standard installation in ‘03-’10 F250/F350 with metal trays under rear seat • 18mm Socket and Ratchet • Torx T-40, and T-43(some cases) Sockets PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION. 1. Flip both rear seats up so they are secured in the upright position. 2. Locate and, using the 18mm socket, remove the OEM bolt that holds the forward edge of the tray in position, it is the second bolt on the driver’s side at the back of the foot well. Set this bolt aside for reinstallation later. 3. Locate and remove the (6) OEM bolts that secure the factory under seat tray to the seat brackets, you will reuse these. 4. Remove the factory tray to make room for the #309. 5. Place the #309 Lockbox in the rear under seat area so that the holes (See Figure #1) in the lockbox align with the threaded holes in the rear seat brackets, and the deeper area of the box is on the driver’s side. FIGURE 1 6. Loosely install the (6) OEM bolts that were set aside in Step 2. NOTE: Do not tighten the OEM bolts as some adjustability is required in the next steps. 7. Adjust the Lockbox’s side to side position so that the gap in the lids aligns with the rear seat split. This may be done by alternately opening the Lockbox lids and raising and lowering the rear seats, and adjusting to minimize interference. 8. Once the Lockbox is in its final position, the (6) OEM bolts may be tightened, and the 18mm bolt(removed in Step 2) may be reinstalled to prevent water from entering the cab of the vehicle. Page 1 of 2 - 6/25/2014 – Rev0

• ½” Socket and Ratchet PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLATION. 1. Flip both rear seats up so they are secured in the upright position. 2. Locate and remove the (6) OEM bolts that secure the factory under seat plastic storage tub, you will reuse these. 3. If equipped, disconnect the electrical connection to the 12V power port by depressing the tab on the connector and pulling apart. Leave the wires in place as the tub may be reinstalled later. 4. Remove the factory storage tub to make room for the #309. 5. Place the #309 Lockbox in the rear under seat area so that the holes (See Figure #1) in the lockbox align with the threaded holes in the rear seat brackets, and the deeper area of the box is on the driver’s side. FIGURE 1 6. Loosely install the (6) OEM bolts that were set aside in Step 2. NOTE: Do not tighten the OEM bolts as some adjustability is required in the next steps. 7. Adjust the Lockbox’s side to side position so that the gap in the lids aligns with the rear seat split. This may be done by alternately opening the Lockbox lids and raising and lowering the rear seats, and adjusting to minimize interference. 8. Once the Lockbox is in its final position, the (6) OEM bolts may be tightened. Call (970)564-1762 for Technical Support Page 2 of 2 - 6/25/2014 – Rev0