TSPROF BLITZ Operation & User’s Manual
Text of TSPROF BLITZ Operation & User’s Manual
Izhevsk, 10 let Oktyabrya str., 60, office 405.
OOO "TSPROF", 426065, the Udmurt Republic,
Manufacturer:
USER MANUAL
TSPROF BLITZ SHARPENING DEVICE
MADE IN RUSSIA
[email protected]
8 (877) 638 82 48
TSPROF.COM
12. Certificate of acceptance and sale..........................................................................................................................13
11. Warranty obligations.......................................................................................................................................................13
10. Utilization........................................................................................................
The manufacturer is not responsible for damages caused by improper use of the devices.
devices may result in personal injury and damage to the device.
Please read these operating User Manual carefully before using the device. Improper operation of the
ATTENTION!
blades.
The TSPROF BLITZ sharpening d
access area of children and animals.
Do not leave unattended the device prepared for operation, open, not covered knife blade in the
Keep in mind that the blade of the knife may cause injury if handled carelessly.
When working with the device, it is recommended to use gloves with cut protection.
edge of the table.
Make sure that
lock (17) counterclockwise until it stops (Fig. 2).
6.1. Open the hinged joint (9) to the working position and, overcoming the resistance of the spring, turn the
The numbers of component parts in the text are indicated by (Fig. 1).
6. PREPARING FOR WORK
with the screw (Fig. 3).
6.2. Insert the abrasive holder (4) into the coupling (7) and secure it
6.3. Insert the assembled abrasive holder into the hinged joint (9) (Fig. 4).
3
Fig. 2)
(Fig.
Long kitchen knives
(Fig. 8)
140х170 mm
(Fig. 9)
(Fig. 10)
(Fig. 11)
Hunting + folding
Folding
Multitools
(Fig. 12)
(Fig. 13)
are shown in the table:
6.Sharpening angles are displayed on a scale with icons of the main types of knives (Fig. 13) and
between the knife and the abrasive.
Icon
Type of the knife
The range of sharpening angles per side
Fillet-knife
Kitchen knife
Hunting knife, EDC knife
Cho
7.1 Select the clamp installation option that matches the shape and size of your knife. Place the
.7 OPERATING PROCEDURE
7.1 knife in the clamps so that the blade reaches the edge of the jaws as close as possible to 17 mm.
7.1 Tighten the clamps with a screwdriver for clamps of 2 mm from the package. The jaws of the
7.1 clamp should fit tightly without gaps to the knife, but excessive force should not be applied when
7.1 tightening, so as not to