TP-Link EAP110 Installation Manual

trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as t ...

CONTENTS English...................................................................................................1 Español.................................................................................................7 Français...............................................................................................13 Português................... ...

Network Topology A typical network topology for the EAP is shown below. EAP Controller A DHCP server (typically a router) is required to assign IP addresses to the EAPs and clients in your local network. A computer running the EAP Controller software, which can be in the same or different subnet w ...

Clip onto the ceiling rail. 3 Attach the mounting bracket to the Ceiling T-rail Clip using four M3x6 pan-head screws. 4 Attach the EAP to the mounting bracket by aligning ARROW 1 (on the EAP) with ARROW 2 (on the mounting bracket), then rotate the EAP clockwise until it locks into place. 5 Connect ...

1 Remove the ceiling tile. 2 Place the mounting bracket in the center of the ceiling tile. Mark the three positions of the screw holes and a 10mm hole for the Ethernet cable to feed through. Drill three 4mm holes and a 10mm hole for the Ether ...

aligning ARROW 1 (on the EAP) with ARROW 2 (on the mounting bracket), then rotate the EAP clockwise until it locks into place. 5 Feed the Ethernet cable through the hole and set the ceiling tile back into place. Connect the Ethernet cable to the ETHERNET port. ■ ■ Option3：Wall Mounting Follow the st ...

holes and drive the self-tapping screws into the anchors. Do not drive the screws all the way in and leave enough clearance to hang the EAP. 4 Hang the EAP on the screws. Make sure the EAP is firmly seated against the wall. 5 Connect the Ethernet cable to the ETHERNET port on the EAP. ...

If the product is provided with a power adapter, power the device via a PSE device (such as a PoE switch) or the power adapter. Via PoE Switch ON/OFF 1 2 Via Power Adapter ON/OFF 1 2 ■ ■ Power via POE Adapter If the product is provided with a POE adapter, power the device via the POE ad ...

Topología de la Red Una Topología de la Red típica para el EAP se muestra a continuación. EAP Controller Se requiere un servidor DHCP (típicamente un router) para asignar las direcciones IP a los EAPs y a los clientes en su red local. Una computadora que ejecute el software del Controlador EA ...

el sujeta-carril en T sobre el carril del techo. 3 Fije el soporte de montaje al sujeta-carril en T para techo usando cuatro tornillos de cabeza plana M3x6. 4 Fije el EAP al soporte de montaje alineando la FLECHA 1 (en el EAP) con la FLECHA 2 (en el soporte de montaje), después rotar el EAP en se ...