Toro 20040 Operator's Manual

indicada más abajo. Asegúrese de indicar el modelo y el número de serie de su producto. Pour obtenir gratuitement une version en français de ce manuel, écrivez à l’adresse ci-dessous. N’oubliez pas d’indiquer les numéros de modèle et de série de votre produit. The Toro Company, Attn: Parts Dept., 8111 Lyndale Ave S, Bloomington, MN 55420 ...

All Rights Reserved Printed in USA 2 Contents Page Introduction 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Safety 3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . General Lawn Mower Safety 3 . . . . . . . . . . . . . . . . . Safety and Instruction Decals 6 . . . . . . . . . . . . . . . . . Assembly 6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Unpacking t ...

space below: Model No. Serial No. This manual identifies potential hazards and has special safety messages that help you and others avoid personal injury and even death. DANGER, WARNING, and CAUTION are words used to identify the level of hazard. DANGER signals an extreme hazard that will cause serious injury or death if you do not follow the recommended precautions. WARNING signals a hazard that ma ...

shrubs, trees, or other objects that may obscure vision. • Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. Preparation • While mowing, always wear substantial footwear and long trousers. • Do not operate the equipment when barefoot or wearing open sandals. • Always wear safety goggles or safety glasses with side shields w ...

if the engine is provided with a shut-off valve, turn the fuel off at the conclusion of mowing. • Stop the blade(s) when crossing gravel drives, walks, or roads. • Shut the engine off and wait until the blade comes to complete stop before removing grass catcher. • Do not operate the mower while under the influence of alcohol or drugs. • If the equipment should start to vibrate abnormally, ...

Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. On Mower Housing (Part No. 43-8480) On Mower Housing (Part No. 93-0248) On Mower Housing (Part No. 99-6018) Assembly Note: Determine the left and right sides of the lawn mower by standing in the operating position. Unpacking the Lawn Mower WARNING POTENTIAL HAZARD • ...

brackets up, aligning the brackets with the holes in the handle (Fig. 2). 3. Secure the handle to the support brackets with the two flat handle bolts and two knobs, using the height adjustment holes on the brackets that best fit your height (Fig. 2). Note: You can adjust the handle height by installing the handle bolt and knob through a different set of holes. 4. Slide the upper handle section ends o ...

combustion deposits and longer engine life. You may use leaded gasoline if unleaded gasoline is not available. IMPORTANT: Do not add oil to the gasoline. IMPORTANT: Do not use methanol, gasoline containing methanol, gasohol containing more than 10% ethanol, premium gasoline, or white gas. Using these fuels can damage the engine’s fuel system. IMPORTANT: Do not use gasoline that has been stored si ...

to 1/2 inch (6 to 13 mm) from the top of the tank. Do not fill into the filler neck. 4. Install the fuel tank cap and wipe up any spilled gasoline. Operation Each time before you mow, make sure that the self-propel drive and the control bar operate properly. When you release the blade control bail, the engine and the blade should stop. If they do not, contact an Authorized Service Dealer. Control ...

to stop the drive, stop walking (Fig. 8). Note: If, when backing up after self-propelling, the lawn mower does not roll backward freely, nudge the lawn mower forward about an inch without engaging the self-propel drive, then pull the lawn mower backward. Adjusting the Cutting Height Each wheel adjusts individually with a wheel height adjustment lever. Cutting heights are 1 inch (25 mm); 1-1/2 inche ...

stirs up more clippings and dust which clogs the air filter and reduces engine performance. • To achieve the best mulching action, set the lawn mower cutting height so the lawn mower cuts no more than a third of the grass blade or a maximum of one-inch- (25 mm) long clippings. If you try to mulch more or if the grass is very lush, the mulching action will be poor. Under these conditions, use the ...

hours or each mowing season. Replace it more frequently in dusty or dirty conditions. X Spark Plug Inspect and clean the spark plug every 25 operating hours. Replace the spark plug every 100 operating hours or when necessary. X Blade Sharpen or replace the blade; maintain it more frequently if edge dulls quickly in ...

Before you use the lawn mower, make sure that the oil level between the Add and the Full marks as shown on the dipstick (Fig. 4). If the oil level is below the Add mark, add oil. Refer to Filling the Crankcase Oil on page 7. Changing the Engine Oil Change the oil after the first five operating hours and then after every 50 hours or every season. Run the engine just before changing the oil to warm the oil. Warm oil flows bet ...

its operating position, and allow the oil to drain into the drain pan (Fig. 12). IMPORTANT: You may need to move the blade to get to the oil drain plug. Move the blade as little as possible to avoid future starting problems. 1 1 2 Figure 12 1. Oil drain plug 2. 3/8-in. Ratchet extension 6. Tip the lawn mower onto its left side and install the oil drain plug. 7. Fill the crankcase with fresh oil to t ...

up (Fig. 13). 4. Remove the dirt and grass clippings with a hardwood scraper. Avoid burrs and sharp edges. IMPORTANT: Move the blade as little as possible to avoid future starting problems. 5. Turn the lawn mower upright. 6. Fill the fuel tank with fresh gasoline. 7. Connect the spark plug wire (Fig. 10). Servicing the Air Filter Clean the air filter pre-cleaner once every season or after ever ...

3. Drain the gasoline from the fuel tank; refer to steps 3 and 4 of Emptying the Fuel Tank on page 18. 4. Drain the oil; refer to Changing the Engine Oil on page 13. WARNING POTENTIAL HAZARD • Gasoline is extremely flammable, highly explosive and under certain conditions can cause personal injury or property damage. WHAT CAN HAPPEN • Tipping the lawn mower may cause fuel leakage from the carburet ...

File the top side of the blade to maintain its original cutting angle (Fig. 20A) and inner cutting edge radius (Fig. 20B). 153 1 
 2
 Figure 20 1. Sharpen at this angle only 2. Maintain the original radius here Note: The blade will remain balanced if you remove the same amount of material from both cutting edges. Balancing the Blade ...

2. Loosen the cable support nut (Fig. 23). m–4205 1 2 3 4 Figure 23 1. Cable jacket 2. Cable support 3. Nut 4. Upper handle 3. Remove the two bolts that secure the belt cover and remove the cover (Fig. 24). 1 2 281 Figure 24 1. Belt cover 2. Bolt 4. Push down on the drive bracket until it contacts the lawn mower, then hold it in place (Fig. 25). m–4273 1 2 Figure 25 1. Drive bracket 2. Push h ...

If a problem continues, see your Authorized Service Dealer. PROBLEM CORRECTIVE ACTION Engine will not start 1. Fill the fuel tank with fresh gasoline. 2. Press the primer three times. 3. Connect the wire to the spark plug. 4. Inspect the spark plug, check the spark plug gap, and replace the spark plug if it is damaged. ...

perform the recommended maintenance procedures. Refer to Maintenance on page 11. Store the lawn mower in a cool, clean, dry place. Cover the lawn mower to keep it clean and protected. WARNING POTENTIAL HAZARD • Gasoline can vaporize if you store it over long periods of time. WHAT CAN HAPPEN • Vaporized gasoline can explode if it comes into contact with an open flame. HOW TO AVOID THE HAZARD � ...