Toro CM Series Operator's Manual

Text of the manual

Form No. 3405-114 Rev A

CM-Series Concrete Mixers Model No. 68004—Serial No. 314000001 and Up Model No. 68006—Serial No. 314000001 and Up Model No. 68007—Serial No. 314000001 and Up Model No. 68008—Serial No. 314000001 and Up Model No. 68009—Serial No. 314000001 and Up G019544 Register at www.Toro.com. Original Instructions (EN) *3405-114* A

Proposition 65 Warning

This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. Use of this product may cause exposu

This manual uses 2 words to highlight information.

Important calls attention to special mechanical information and Note emphasizes general information worthy of special attention. Tire Information The DOT tire information is located on the side of each tire. This information gives load and speed ratings. Replacement tires shou

Improperly using or maintaining the machine can result

in injury. To reduce the potential for injury, comply with these safety instructions and always pay attention to the safety alert symbol , which means: Caution, Warning, or Danger—personal safety instruction. Failure to comply with the instruction may result in personal injury or death. Safe Ope

Become familiar with the safe operation of the equipment,

operator controls, and safety signs. • Use only accessories and attachments approved by the manufacturer. • Wear personal protective equipment and appropriate clothing, including the following: – Hard hat – Respirator or dust mask – Face shield – Hearing protection – Substant

Maintenance and Storage

• Before performing maintenance, do the following: – Park the machine on level ground. – Shut off the engine. Wait for all movement to stop before adjusting, cleaning, or repairing. – Let the engine cool before performing maintenance or storing. – Disengage all power and operation controls. • Never lubricate, service, repa

Safety and Instructional Decals

Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 117-2718 125-4940 1. Warning 3. Engine—shut off 2. Engine—run 125-8175 1. Read the Operator’s Manual for information on greasing the machine. 125-8216 1. Read the

Toxic gas inhalation

hazard—Don’t run the engine in an enclosed space. 2. Hand and arm entanglement at the belt drive; crushing hazard of hand; entanglement hazard of hand at the shaft—keep hands away from moving parts; keep all guards and shields in place. 5. Explosion hazard—shut off the engine

Other Construction Equipment Manuals