T3 Technology A4262 Wi-Fi6 Quick Start Manual

Product Backside Description Short press (1 second) for reset the router Long press (5 seconds or longer) for reset to factory default settings ...

Blinking Green Network connection in progress Steady Green Function normally and can access the Internet Blinking Blue WPS or Mesh pairing in progress Steady Blue Paring successful ...

(i.e. cable/DSL modem, PON gateway). Please refer to SINGLE ROUTER SETUP STEPS for network setup. For Mesh Router Set: Master AP is used as the main router, which is to be connected, via provided network cable, to your home Broadband Gateway ( ...

01. The Single Router or Master AP in a Master Router Set can be connected according to the diagram above. It is connected to the Internet when the LED light is steady green. If you can, try place the Single Router or Master AP in an open area like on a table or a shelf. 02. Wired devices can be connected directly to ports 2,3 or 4 for ...

01 Wireless access terminals (such as mobile phones, PAD, laptops, etc.) or wired access terminals can open the browser to visit http://192.168.0.1, and configure the router device. 02 Password needs to be set for the first time login, click "Next". Please remember th ...

"Next". ! Note: If you forget your broadband account password, you can inquire from the broadband operator. ! Note: "Skip" defaults to "DHCP" mode. 04 Set Wi-Fi name and password (you can modify the Wi-Fi name). The device selects “The password is the same as the lo ...

After "Confirm", the wireless terminal can reconnect to the new Wi-Fi name and password. ※ Please refer to the following steps to switch Router to Bridge mode: 01 Log in to the http://192.168.0.1 page using the login password. 02 Change the "Uplink mode" to "Bridge Mode" on the "WAN Settings" pag ...

 If you choose wired networking, connect the new single product network port to the Master AP network port. The wired network is successful when the new single product indicator is steady green;  If you choose wireless networking, place the new item near the Master AP, press both devices WPS buttons for 1s, then release. The Master ...