Sharp CD-BK3100W Operation Manual
Text of Sharp CD-BK3100W Operation Manual
MANUAL DE MANEJO
SHARP CORPORATION
MODEL
MODÈLE
MODELO
CD-BK3100W
MINI COMPONENT SYSTEM
MINI-CHAÎNE
SISTEMA MINI
CD-BK3100W Mini Component System consisting of CD-BK3100W (main unit) and CP-
BK3100 (speaker system).
Mini-chaîne CD-BK3100W composée de CD-BK3100W (appareil principal) et de CP-
BK3100 (enceintes acoustiques).
Sistema mini CD-BK3100W que consta de CD-BK3100W (aparato principal) y CP-BK3100
(sistema de altav
- Introduction / Special Notes -
Introduction
Thank you for purchasing this SHARP product. To obtain the best performance from
this product, please read this manual carefully. It will guide you in operating your
SHARP product.
Special Notes
z When the ON/STAND-BY button is set at STAND-BY position, mains voltage is still
present inside the unit. When the ON/STAND-BY button is set at STAND-BY posi-
tion, the unit ma
- Accessories / Contents -
Accessories
Please confirm that the following accessories are included.
Note:
Only the above accessories are included.
Contents
Page
„ General Information
Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Controls and Indicators . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 6
„ P
- Precautions -
Precautions
„ General
z Please ensure that the equipment is positioned in a well-ventilated area and
ensure that there is at least 10 cm (4") of free space along the sides, top and back
of the unit.
z Use the unit on a firm, level surface free from vibration.
z Keep the unit away from direct sunlight, strong magnetic fields, excessive dust,
humidity and electronic/electrical equipment (home computers, facsi
Sharp CD-BK3100W - Controls and Indicators -
Controls and Indicators
„ Front panel
Reference page
1. Disc Trays . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
2. Timer Set Indicator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28
3. CD Direct Play Buttons . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16, 17, 25
4. CD Eject Buttons . . . . . . . . .
- Controls and Indicators - Controls and Indicators (continued)
„ Display
1. CD Music Schedule Indicators
2. CD Indicators
3. FM Stereo Mode Indicator
4. FM Stereo Receiving Indicator
5. Memory Indicator
6. CD Random Play Indicator
7. Tape 2 Record Indicator
8. Extra Bass Indicator
9. Timer Recording Indicator
10.Timer Play Indicator
11.Sleep Indicator
12.Spectrum Analyser/Volume Level Indicator
13.CD Play Indicator
14.CD
- Controls and Indicators - „ Remote control
Reference page
1. Remote Control Transmitter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
2. Echo Level Up and Down Buttons . . . . . . . . . . . . . . . . . . . . . . . . . . 22
3. Karaoke Mode Button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
4. CD Direct Play Buttons . . . . . . . . . . . . . . . . . . . . . . . . . . .
Preparation for Use
- System Connections -
System Connections
VCR, DVD, etc.
AM loop aerial
Right speaker
Left speaker
FM aerial
not supplied
Transport screw
To a wall socket
(See page 9. )
Preparation for Use - System Connections -
„ Removing the transport screw
Before turning the power on, be sure to remove the transport screw on
the back of the unit using a flat-blade screwdriver or a coin.
Note:
This screw is required when transporting the unit again. Please keep it (see page 31).
„ Aerial connection
Note:
Placing the aerial on the unit or near the AC power lead may cause noise pickup.
Place the aerial away from the unit
Preparation for Use - System Connections -
System Connections (continued)
„ Placing the speaker system
The left and right speakers have individual shapes. For best performance, place the
speakers according to the diagram below.
Bi-amp system:
Each speaker unit has a built-in subwoofer (low frequency range) which is driven sep-
arately from the woofer and tweeter (mid-to-high frequency range). Two independent
amplifiers which have individual f
Preparation for Use - System Connections / General Control -
„ Setting the FM/AM span selector
The International Telecommunication Union (ITU) has established that member coun-
tries should maintain either a 100 kHz or a 50 kHz interval between broadcasting fre-
quencies of FM stations and 10 kHz or 9 kHz for AM station. The illustration shows
the 50/9 kHz zones (regions 1 and 3), and the 100/10 kHz zone (region 2).
Before using the unit, se
Preparation for Use - Remote Control -
Remote Control
„ Battery installation
Precautions for battery use:
z Replace all old batteries with new ones at the same time.
z Do not mix old and new batteries.
z Remove the batteries if the unit will not be used for long periods of time. This will
prevent potential damage due to battery leakage.
Caution:
z Do not use rechargeable batteries (nickel-cadmium battery, etc.).
z Installing the batteries in
- Sound Control -
Sound Control
„ Volume control
Main unit operation:
When the VOLUME control is turned clockwise, the volume will increase. When it is
turned anti-clockwise, the volume will decrease.
Remote control operation:
Press the VOLUME button to increase the volume and the VOLUME button for
decreasing.
„ Bass control
When the power is first turned on, the unit will enter the extra bass mode which
emphasises the ba
- Setting the Clock -
Setting the Clock
In this example, the clock is set for the 24-hour (0:00) display.
Note:
The "CLOCK" or time will flash at the push of the CLOCK button when the AC power
supply is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the Clock" from the beginning. If the time display is flashing, step 3
(for selecting the 24-hour or 1
- Listening to a CD (CDs) -
Listening to a CD (CDs)
This system can play audio CD-R and CD-RW discs just as CD discs, but cannot per-
form recording. (However, some CD-R and CD-RW discs may not be played.)
„ To play discs in turn (from Disc 1 to Disc 6)
Note:
The system will search CD trays until it finds a CD and will not search the rest of the
trays.
Continued to the next page
1 Press the ON/STAND-BY button to turn the power on
- Listening to a CD (CDs) - Listening to a CD (CDs) (continued)
To interrupt playback:
Press the button on the remote control.
To resume playback from the same point, press the
button.
To stop playback:
Press the button.
To exchange other CDs whilst playing a disc:
Press CD eject button for any stopped CD from 1 to 6 and exchange discs.
To remove the CDs:
Whilst in the stop mode, press the CD eject button for any CD from 1
- To Specify a Disc to Play / Repeat or Random Play -
To Specify a Disc to Play
You can play a disc by specifying the disc number.
Note:
Among discs 1 - 6, those with whitely illuminated CD indicators in the frame can be
played. However, if the button of the disc tray with no disc is pressed, playback will not
start and the indicator in the frame will go out.
To stop playback:
Press the button.
Repeat or Random Play
„ Repeat Pla