Progress PVS1550 Operation & User’s Manual

Text of Progress PVS1550 Operation & User’s Manual

PVS1550 User Manual Notice d'utilisation Benutzerinformation Dishwasher Lave-vaisselle Geschirrspüler all-guides com

Before first use

9 Daily use 10 Hints and tips 12 Care and cleaning 13 Troubleshooting 15 Technical information 18 Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are th

– by clients in hotels, motels, bed & breakfast and other

residential type environments. • Do not change the specification of this appliance. • The operating water pressure (minimum and maximum) must be between 0.5 (0.05) / 8 (0.8) bar (MPa) • Obey the maximum number of 9 place settings. • If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard

Progress PVS1550 Make sure that there is access to the

mains plug after the installation. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. • This appliance complies with the E.E.C. Directives. • Only for UK and Ireland. The appliance has a 13 amp mains plug. If it is necessary to change the fuse in the mains plug, use fuse: 13 amp ASTA (BS 1362). Water connection • Do not cause damage to the water hoses. • Before connection t

Upper spray arm

2 Lower spray arm 3 Filters 4 Rating plate 5 Salt container 6 Air vent 7 Rinse aid dispenser 8 Detergent dispenser 9 Cutlery basket 10 Lower basket 11 Upper basket CONTROL PANEL 1 2 3 4 1 On/off button 2 Programme buttons 3 Delay button 4 Indicators Progress 5

Progress PVS1550 Salt indicator. It is always off while the programme operates.

PROGRAMMES Programme Degree of soil Type of load Programme phases Options 1) • Normal soil • Crockery and cutlery • Prewash • Wash 50 °C • Rinses • Dry • XtraDry 2) • Heavy soil • Crockery, cutlery, pots and pans • Prewash • Wash 70 °C • Rinses • Dry • XtraDry • Normal soil • Crockery and cutl

12 - 14

1.2 - 1.4 140 - 160 12 - 14 1.0 - 1.2 100 - 120 8 0.9 30 4 0.1 14 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values. Information for test institutes For all the necessary information for test performance, send an email to: [email protected] Write down the product number (PNC) that is o

29 - 36

51 - 64 5.1 - 6.4 36 - 45 7 23 - 28 40 - 50 4.0 - 5.0 28 - 35 6 19 - 22 33 - 39 3.3 - 3.9 23 - 27 5 1) 15 - 18 26 - 32 2.6 - 3.2 18 - 22 4 11 - 14 19 - 25 1.9 - 2.5 13 - 17 3 4 - 10 7 - 18 0.7 - 1.8 5 - 12 2 <4 <7 <0.7 < 5 1 2) 1) Factory setting. 2) Do not use salt at this level. Whether you use a standard detergent or multi-tabs (with or without salt), se

Desired options must be

activated every time before you start a programme. It is not possible to activate or deactivate options while a programme is running. Not all options are compatible with each other. If you have selected non compatible options, the appliance will automatically deactivate one or more of them. Only the indicators of the options still active will stay on. XtraDry Activate this option when you want to boost the drying performance

5. Turn the cap of the salt container

clockwise to close the salt container. CAUTION! Water and salt can come out of the salt container when you fill it. After you fill the salt container, immediately start a programme to prevent corrosion. How to fill the rinse aid dispenser A B D C M A X 1 2 3 4 + - A B D C CAUTION! Only use rinse aid specifically designed for dishwashers. 1. Press the release button (D) to open the lid (C). 2. Pour the rinse aid in the

1. Press the release button (B) to open the

lid (C). 2. Put the detergent, in powder or tablets, in the compartment (A). 3. If the programme has a prewash phase, put a small quantity of detergent in the compartment (D). 4. Close the lid. Make sure that the release button locks into position. Setting and starting a programme The AUTO OFF function This function decreases energy consumption by deactivating automatically the appliance when it is

Progress PVS1550 End of the programme

When the programme is completed the indicator comes on. If you do not deactivate the appliance within 5 minutes all indicators goes off. This helps to decrease energy consumption. 1. To deactivate the appliance press the on/off button or wait for the AUTO OFF function to automatically deactivate the appliance. 2. Close the water tap. HINTS AND TIPS General The following hints will ensure optimal cleaning and drying results in daily us

• Do not put in the appliance items that

can absorb water (sponges, household cloths). • Remove remaining food from the items. • Make soft the remaining burned food on the items. • Put hollow items (cups, glasses and pans) with the opening down. • Make sure that cutlery and dishes do not bond together. Mix spoons with other cutlery. • Make sure that glasses do not touch other glasses. • Put small items in the cutlery basket. • Put light ite

2. Remove the filter (C) out of filter (B).

3. Remove the flat filter (A). 4. Wash the filters. 5. Make sure that there are no residues of food or soil in or around the edge of the sump. 6. Put back in place the flat filter (A). Make sure that it is correctly positioned under the 2 guides. 7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. CAUTION! An incorrect position of the filters

• If you regularly use short duration

programmes, these can leave deposits of grease and limescale inside the appliance. To prevent this, we recommend to run long duration programmes at least 2 times per month. • To maintain the performance of your appliance at its best, we recommend to use monthly a specific cleaning product for dishwashers. Follow carefully the instructions on the packaging of the product. TROUBLESHOOTING If the appliance does not st

Problem and alarm code

Possible cause and solution The appliance does not drain the water. • The end indicator flashes 2 times in- termittently. • Acoustic signal sounds 2 times inter- mittently. • Make sure that the sink spigot is not clogged. • Make sure that the drain hose has no kinks or bends. The anti-flood device is on. • The end indicator flashes 3 times in- termittently. • Acoustic signal sounds 3 times inter- mittently. • Close the

Progress Dishwasher Owners Instructions: