Premier Mounts MVW463 Installation Manual

1321 S. State College Blvd., Fullerton, CA 92831 USA Installation Guide MVW463 Video Wall Frame ...

Level Required for installation Warning Statements MVW463 Installation Guide www.mounts.com | North America 800.368.9700 | International +1-714-632-7100 Prior to the installation of this product, these installation instructions must be read and completely understood. Keep these installation instructions in an easily accessib ...

Video Wall Frame (Qty 1) 6mm Quick-Release Button (Qty 4) 8mm Quick-Release Button (Qty 4) Universal Spacer (Qty 4) M8 x 16mm Set Screw (Qty 4) M6 x 20mm Screw (Qty 4) M6 x 25mm Screw (Qty 4) M8 x 16mm Screw (Qty 8) M8 x 20mm Screw (Qty 4) M8 x 25mm Scre ...

1 Dual-Pole Cart or Stand Installation Illustrations show only some of the installation configurations possible with the MVW463’s. Figure 1 Make sure the MVW463 keyhole mounting slots are in the correct orientation for portrait or landscape orientation ...

2 The arrows show where the M8 x 16mm pan Phillips screws can go from inside to fasten MVW463’s together. Figure 1 Full View Top/Bottom View Side View If you are fastening multiple MVW463’s, use the M8 x 16mm pan Phillips screws provided to fasten th ...

5 4 3 1) Slide the MVW463 to the desired height on the dual-pole cart or stand. 2) Insert four (4) M8 x 10mm set screws into the MVW463 screw holes near the tubing (see drawing). 3) Tighten the screws against the MVW463 and tubing. Back-View Closeup of M ...

6 Flying Installation Illustrations show only some of the installation configurations possible with the MVW463’s. Figure 1 Figure 2 Figure 3 The keyhole mounting slots should point downward. MVW463 Heavy-Duty Steel Tube MVW463’s Heavy-Duty Steel Tub ...

7 Page 8 The arrows show where the M8 x 16mm pan Phillips screws can go from inside to fasten MVW463’s together. Figure 1 Full View Top/Bottom View Side View If you are fastening multiple MVW463’s, use the M8 x 16mm pan Phillips screws provided to f ...

1) Slide the MVW463 to the desired position against the tube. 2) Insert two (2) M8 x 10mm set screws into the corner screw holes above the tube (Figure 1). 3) Tighten the screws against the MVW463 and the tube. 4) Inside the MVW463, wrap and secure riggi ...

Page 10 1) Use the rigging/flying hardware to safely suspend the MVW463(s) overhead. 2) To set the tilt angle, attach additional cables to the bottom of the frames and pull to the desired angle (see drawing). Re-check all hardware and installatio ...