Precaster LDM60 Operation Manual
Text of Precaster LDM60 Operation Manual
Please contact your local dealer or contact us through service email :
[ [email protected] ] for further assistance.
Service Support
Safety Information
Inside the Box
a. Laser Distance Meter x 1
b. Carrying Case x 1
c. AAA Batteries x 2
d. Safety Strap x 1
e. Quickstart Card x 1
a. This is a Class 2 laser tool, laser radiation is emitted from this product and is manufactured to
comply IEC 60825-1: 2007, EN 60825-1:2007, EN 61326-1:
NEW BENCHMARK OF MEASURING
1
Error Code
Specification
Err01
Err02
Err03
Out of measuring range
Measuring in a proper range
Reflected signal is too weak
Pythagorean calculation error
Low Battery
Out of working temperature
Ambient light is too strong
Check and verify values and
steps are correct
Install new batteries
Measure in an environment
within specified working
temperature
Measure in a darker place
(shadow target)
Select a better surface
Out of disp
B. Single measure / Tap and hold
continuous measure
C. Addition
D. Subtraction / Tap and hold to
change unit
E. Clear / Power
F. Distance Measurement (Area ->
Volume -> Stake out -> Single
measure) / Tap and hold to set
up (volume -> 20 measurement
records)
G. Indirectly height (Indirectly
height measure I -> II -> III ) /
Tap and hold to set up the
measure (the top of device ->
the end of device)
H. Receiving Lens
NEW BENCHMARK OF MEASURING 3
i. This unit is powered by 2 x AAA Batteries.
ii. Remove battery lid and observing correct polarity before install batteries.
iii. When the icon appears , it mean fully charged battery.
iv. When the icon appears, there are approximately 1000 times to measure.
v. Replace batteries when low battery icon flash on screen.
Battery Installation & Power Status
Measurement Reference
1. There are two r