Panasonic CF-VEB Series Operating Instructions Manual

D Bezeichnungen der Teile .................................... 13 Anschließen/Entfernen ....................................... 15 Names of Parts ...................................................... 5 Connecting/Disconnecting................................... 7 OPERATING INSTRUCTIONS ................. 4 E Port ...

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equip- me ...

This equipment is in conformance with the requirements of the European Council Directive listed below: 73/23/EEC Low Voltage Directive with amendment 93/68/EEC 89/336/EEC EMC Directive with amendments 92/31/EEC and 93 ...

series.* By connecting your peripheral devices to the port replicator, you can save yourself the trouble of having to connect and disconnect several cables every time you transport the computer. * This port replicator cannot be used for other models. Port Replicator... ...

The port replicator allows your peripheral devices to function exactly as if they were con- nected directly to the computer. (Refer to “Names and Functions of Parts” in the “Operating Instructions” accompanying the computer.) Do not touch the expansion bus connector, pins or terminals of the port replicator. DC-IN Jack Rear CAUTION ...

puter. When the port replicator is not con- nected to the computer, be sure that the le- ver remains in the “UNDOCK” position to- wards the rear of the unit. This connects to the expansion bus connec- tor on the bottom of the computer. Be sure to keep it covered with the supplied protective cap when th ...

in the standby or hibernation mode. CAUTION 1 Turn off the computer, and disconnect all cables from the computer. Do not use other than the specified AC adaptor (Model No. CF-AA1623A) and AC cord. Refer to the “Operating Instructions ...

Protective Cap Cap Holder 2 1 Lever Latch CAUTION Do not slide the lever without holding the latch to the right side. 1 2 6 Remove the expansion bus connector protective cap and place it in the cap holder to prevent its getting lost. 7 While holding the latch to the right side, slide the lever all the way ...

If your computer is a model in the CF-18Bxxxxxx series, install the driver by following the procedure below after connecting the computer to the port replicator. If your computer is not a model in the CF-18Bxxxxxx series, refer to “Port Replicator” in the computer’s “Reference Manual.”

clude this location in the search:], and then input [d*1:\lan]. 7 Select [Next]. 8 Select [Continue Anyway]. 9 Select [Finish]. *1 “d” is the letter used for the CD drive. You can change the letter to suit your preference.