Range Road RR607 Assembly Manual

Text of the manual

Range Road Enterprises Ltd

Box 944 Eckville AB T0M 0X0 www.range-road.ca RR607 Trailer Assembly Manual 1.) Unpack all pieces from the tub & crate, empty bag with nuts, bolts and pins onto a flat surface. 2.) Find the main frame, lay on the floor with axle tabs facing up. 3.) Place the walking beams between the tabs on either side, there is not a right or lef

Range Road Enterprises Ltd

Box 944 Eckville AB T0M 0X0 www.range-road.ca 5.) Grease both swivel pins. 6.) Install all 4 tires and tighten wheel nuts to 40ft/lbs. 7.) Flip frame section over so that the frame is higher than the walking beams. 8.) Install frame tube into main frame, holes at coupler end face up & down. 9.) Large bolt goes through frame tube an

Range Road Enterprises Ltd

Box 944 Eckville AB T0M 0X0 www.range-road.ca 10.) Slide battery box onto frame tube and then slide the tongue jack on. 11.) Slide the swivel coupler mount in, position the swivel up or down depending on your ATV hitch height, tighten both bolts. 12.) Grease swivel. 13.) Slide tongue jack to desired position, usually about 15cm (6�

Range Road Enterprises Ltd

Box 944 Eckville AB T0M 0X0 www.range-road.ca 15.) Install hydraulic pump mounting 2 -16mm bolts from under the frame, use the supplied nuts as spacers to make sure the pump is held tight to the frame. 16.) Install hydraulic hose, mount to pump and cylinder, use tabs on frame to hold the hose. 17.) Tighten all nuts holding wires, o

Range Road Enterprises Ltd

Box 944 Eckville AB T0M 0X0 www.range-road.ca 22.) Line up holes and insert pins, lock pins in place with safety clips. 23.) Install 4 plastic covers into frame ends. 24.) Mount 2 reflectors on mounts at rear of tub. 25.) Mount the cylinder to the ears on the bottom of the tub frame, push pin through and lock with a cotter pin. 26.

Other Utility Vehicle Manuals