SFS Soter Installation Manual

Typical Fall Arrest System layout Fall Arrest When a work restraint system cannot be feasibly offered, then a fall arrest system can then be considered. Fall arrest systems are designed to ‘limit the consequences of a fall should it occur’. The Soter HLL system will arrest a users’ fall, only if the required fall clear ...

3 Free-Fall Clearances Free fall clearances are often overlooked when a fall arrest system is designed. It’s imperative they are calculated using a calculation programme by the manufacturer, to prove that if a fall was to occur, the distances required for the system to effectively arrest the users fall can be assured. System ...

Use 8 no. PA Sleeve’s and TI Screws for concrete / Using 8 no. PA sleeves and BS screws for 18mm Ply /OSB Board or 0.7mm Metal deck or tongue and groove deck ➊ Ascertain location of base plate picking up the crown or trough of the deck based on the fixing length supplied. ➍ With all 8 fixings installed turn S2 can on ...

5 ➋ Mark on the termination where the wire ends. This shows where the hollow part of the termination ends, and where the first crimp will be located. ➎ Mark on the termination where the wire ends. This shows where the hollow part of the termination ends, and where the first crimp will be located. This needs to be done on ...

Step 3 Cutting & tensioning ➎ By holding the crimped barrel and line in one hand the turnbuckle/ central barrel of the tensioner can be turned tensioning the line with the other hand. ➏ Once the required amount of tension has been achieved the red tension indicating disc will loosen and can be turned. Although this ind ...

7 Final tightening & system tagging It is important that all installed systems are fitted with a certification tag at the point of access, similar to the tag shown opposite. Conforming to BS EN 365:2004 The certification tag should include the following information to support the more detailed O&M Manual: n Contract number/na ...

Material: Carbon steel Coating: zinc electroplating Diameter: 4 mm Drive: TORX ® T20 WFR-T-T20-4,5 x L Material: Carbon steel Coating: zinc electroplating Diameter: 4,5 mm Drive: TORX ® T20 WFR-T-T25-5 x L Material: Carbon steel Coating: zinc electroplating Diameter: 5 mm Drive: TORX ® T25 WFR-T-T30-6 x L Material: Carbon s ...