RPB L4 light Instruction Manual

Responsibilities (page 4). PRODUCT USERS: Read this manual and follow the Product User Safety Instructions (page 5). Manuals are regularly updated. Make sure this manual is available to all users for reference. CURRENT VERSION OF MANUAL AND OTHER LANGUAGES: rpbsafety.com/saf ...

2  INTRODUCTION 3  IMPORTANT SAFETY INFORMATION  PROTECTION PROVIDED AND LIMITATIONS 4  EMPLOYER RESPONSIBILITIES 5  PRODUCT USER SAFETY INSTRUCTIONS 6  SETUP AND CARE 7  INSTALLATION AND USE 8  PARTS AND ACCESSORIES 11  WARRANTY AND LIABILITY STATEMENT 12  NEDERLANDS 13 ...

2807 Samoset Rd, Royal Oak, MI 48073, USA. T: 1-866-494-4599 F: 1-866-494-4509 E: [email protected] rpbsafety.com RPB® SAFETY - APAC 1 Ivan Jamieson Place, Christchurch Airport, Christchurch 8053 New Zealand. T: +64-3-357-1761 F: +64-3-357-1763 E: [email protected] rpbsafety.com RPB® SAFETY - EMEA T: +44-8 ...

 The temperature is outside the range of 14°F to 140°F (-10°C to +60°C).  When flammable or explosive atmosphere is present.  Under water or in excessively wet conditions.  When the battery is damaged or with non RPB® batteries or battery chargers. PROTECTION PROVIDED AND LIMI ...

Make sure that equipment is properly set up, inspected, fitted, used, and maintained, including using only RPB® batteries and chargers made specifically for the L4™ Light.  Dispose of the battery in accordance with local regulations.  If you have any questions, contact RPB®.  ...

2 bright white LEDs. When starting fully charged, the battery should last around 4 hours. POWER ON/OFF The L4™ Light has one power setting. To turn the unit on or off, simply press the button on the battery pack. ENVIRONMENTS The L4™ is a sealed un ...

2. 20-95% faster bulk charge (Orange LED) 3. 95-100% Slow trickle charge (Flashing Green LED) Before using the light for the first time, make sure a full charge is performed. Battery Care  Do not use the battery outside the recommended temperature limits 14° F to 131° F (-10° C to 55° C).  Do not charge the ...

fit the Locking Clip over to secure the band to the helmet, making sure that the band is sitting neatly on the center of the helmet and that the light is held securely in place. Tape Remove the backing from the double sided tape on the back of the L4™ Light. Locate the L4™ on the front of the Helmet makin ...

and off. Attach the straight section of the Power Cable to the Breathing Tube with Cable/Hose Clips so that the Connector is positioned to connect to the connector on the back of the L4™ Light unit and the coiled section is hanging off the bottom of the breathing tube. Thread on the Breathing Tube to the Helmet ...

light unit by unclipping it from the sides. Excessive wear of this item will effect the efficiency of the brightness of the light and format of the light. Place the new Outer Lens onto the front of the L4™ Light unit and press firmly into place so that the side clips snap lock into position. FIGURE 2.9 FIGURE 2. ...