SelectBlinds ERB25 Instruction Manual

SETTING button battery pack for more than 3 seconds Rlease this button when motor jogs 2 Press the CONFIRM button on transmitter Motor jogs, the program has been done. 1 Press UP button If motor goes up, please do nothing, If motor goes down, please do next step 2 Press and hold LIMIT button then press STOP button Release both buttons when motor jogs 3 Press UP button Motor goes up, the motor rotation direction has been revised 1 Keep pressing LIMIT button on any programmed transmitter Rleasethis button when motor jogs 2 Press DOWN button on transmitter Motor runs down 3 Press STOP button When motor running close to the end-point of bottom limit Motor stops 4 Press either UP or DOWN button Motor runs step by step to adjust bottom limit accurately 5 Press CONFIRM button on transmitter Motor jogs, down way setting has been done. The whole limit setting must be finished at one times ●Please skip the step and go to next If manufacturer has programmed a transmitter with motor before delivery ERB25 Rechargeable Battery Motor Instruction Technical data Motor Load Torque: 0.7Nm/34rpm 1.1Nm/28rpm Battery Specification: Li-ion Batter, 2000mAH, 7.4V. Notify: ●The side of motor head with SETTING button should face to you ( toward outside) ●Motor antenna should be as straight as possible in the position far away from metal objects. Directly contact metal objects is prohibited; otherwise, the receivindistance will be influenced seriously. ●Please charge the battery when the motor alarm or work faltering Setup bottom limit Program the first transmitter with motor Change motor rotate direction

transmitter Motor runs up 7 Press STOP button When motor running close to the end-point of upper limit Motor stops 8 Press either UP or DOWN button Motor runs step by step to adjust lower limit accurately 9 Press CONFIRM button on transmitter Motor jogs, the setting has completed. 1 Press DOWN button Stop motor at the position which you need 2 Press and hold LIMIT button then press UP button Release both buttons when motor jogs, now the setting has completed 3 Press STOP button when motor stop Motor will run to the setting position and stops 1 Keep pressing LIMIT button on the first programmed transmitter A, then press CONFIRM button Please release both buttons once motor jogs 2 Press CONFIRM button on transmitter B Motor jogs again, now transmitter B has programmed with motor Delete all other transmitters 1 Keep pressing LIMIT button on transmitter A, then press DOWN button Please release both buttons once motor jogs,now all tramsitters have been deleted except A Delete itself from motor 2 Press CONFIRM button 3 times This transmitter has been deleted from the motor Charging FAQ The motor works with Li-ion battery, please charging it when the motor alarms or work faltering. Please charge the motor using professional charger CH-8.4V/1A Charging time: Charger 4 hours or indicator change to green 1 hours, please take the charger away when charging full. If nothing works, please check: ● please charging the motor battery firstly ● If the motor runs to a direction continually, the user didn't setup limit successfully, please re-set limit. Set intermediate position This step only can be done after setting motor limit Program transmitter using a programed transmitter ● Please skip the step and go to next if the subsidiary transmitter is not needed Setup upper limit