IntelligentAg RECON Troubleshooting Manual

600820-000012, rev 1.4 Page 2 of 15 Recon Wireless Blockage and Flow Monitor Troubleshooting Guide © 2014 - 2019 Intelligent Agricultural Solutions All Rights Reserved. Recon Wireless Blockage and Flow Monitor Troubleshooting Guide. All content within is copyrighted by Intelligent Agricul ...

600820-000012, rev 1.4 Page 3 of 15 Table of Contents Access Point ............................................................................................................................ 5 Why am I losing power to the TP-Link access point? ............................................. ...

600820-000012, rev 1.4 Page 4 of 15 Record of Revisions Revision Number Change Description Revision Date Inserted By 1.0 Initial Release 11/13/14 AAL 1.1 Improved document navigation, added topics 8/19/15 AAL 1.2 Added information about the Intelligent Ag Pro app, general updates. 2/21/17 ...

600820-000012, rev 1.4 Page 5 of 15 TIP: If you don’t see your problem listed or your problem is not resolved after completing all troubleshooting steps, contact your Intelligent Ag dealer for assistance. Access Point Why am I losing power to the TP-Link access point? Verify that the con ...

600820-000012, rev 1.4 Page 6 of 15 Why won’t the app connect to the access point? 1. If you didn’t allow location services, re-enable them. a. Delete and re-download the app. i. On the iPad home screen, press and hold on the app icon. Tap Rearrange Apps, then tap the X when it appears ...

600820-000012, rev 1.4 Page 7 of 15 ECU Does the ECU’s orientation matter? Intelligent Ag recommends installing the ECUs facing forward/toward the cab of the tractor so that the LED is visible from the TP Link access point or gateway, allowing for optimal communication with the access po ...

600820-000012, rev 1.4 Page 8 of 15 There is power to the ECU, but the ECU isn’t functioning. • If the Power LED is on: o Slow blinking LED (about one blink every 3 seconds) 1. Verify that the iPad is connected to the “IASBlockage” or “IASNetwork2” Wi-Fi network. 2. Disconnect ...

600820-000012, rev 1.4 Page 9 of 15 Why is there a Wi-Fi symbol over an ECU in the app? You have lost connection to that ECU. 1. Close and re-open the app. 2. Check for possible Wi-Fi interference. a. Disconnect any of the following devices: wireless camera (disconnect both the cab display ...

600820-000012, rev 1.4 Page 10 of 15 My ECUs are not updating correctly. Complete one of the options below to update the ECUs. Option 1 may have more downtime from the operator, but is less labor intensive. Option 2 is usually most effective, but more labor intensive. Option 1: 1. Complete ...