keilhauer Buncha Assembly Manual

Text of keilhauer Buncha Assembly Manual

1450 Birchmount Road

Toronto, Ontario, Canada M1P 2E3 T 416 759 5665 F 416 759 5723 1 800 724 5665 Buncha Assembly Guide

Hex Allen Key

Hardware Included Buncha Non - Powered Assembly Instructions 1/4-20 x 3/4” Hex button head cap screw (x32) Place the table top upside down on a blanket. Using the hex key, fasten the four legs with 1/4-20 x 3/4” Hex button head cap screw (x32). Proceed to flip the table top into its final position. 1 2 3 Phillips Driver 2

Buncha with Power Assembly Instructions

Tool Required Hex Allen Key Hardware Included 1/4-20 x 3/4” Hex button head cap screw (x32) Cable management clips (x2) Cable management Adhesive velcro loops (x4) Mini Tap clamp bar Mini Tap thumb screw (x2) Power Box Place the table top upside down on a blanket. Power Leg (x1) 1) This leg includes a channel for the power cable. Ensure this leg is fastened to the corner nearest the power outlet source.

Place the channel leg cover over the channel leg. Firmly

press on the cover to ensure it is set in place and sits flush with the leg. Buncha with Power Assembly Instructions (Continued) 5 6 Place self adhesive cable management clip (x1) at the location above. Unpackage the adhesive tabs with velcro (x2) that accompany the control box, then proceed to place them on the underside of control box. Fasten control box to underside of table at the location above.

Place (x1) self adhesive cable management clip at the

location above. Flip over and place the table in its final position. 16 In order to link the power connection between multiple tables, only one table requires the power leg. All additional tables ( maximum of x7) can be powered by using the daisy chain extension piece above (Short cord). Power Linking Buncha Tables 11 15 EXTREME HAZARD WARNING: IN ORDER TO PREVENT ELECTRICAL DAMAGE AND/OR FIRE, A MAXIMU

Buncha Ganging Instructions

Table 1 Table 2 Tool Required Hardware Included Phillips Driver 1/4 - 20 x 3/4” Phillips (x4) Ganging Mechanism (x2) Top view Side view Underside view Table 1 Table 2 B Male component A Female component A A B B Underside view 1 Locate the two pilot holes located at each end of the underside of the table. With the Phillips driver, fasten the ganging mechanism to each end of the table using (x2) 1/4 - 20 x 3/4�

Modesty Panel Assembly Instructions

Place the table on its edge on a blanket. Flip over and place the table in its final position. 1 4 1) Slide the modesty screen onto the table legs. 2) Insert the modesty panel clips onto the top edge of the modesty panel, then proceed clip them into the pilot holes on the underside of the table top. 3 Modesty Panel Clip (x7) Hardware Included for Modesty Panel When installing the modesty panel, ensure the folded

keilhauer Indoor Furnishing Owners Instructions: