Juniper J-Series Quick Start Manual

Release 8.0 29 June 2006 Part No. 530-016610-01 Revision 1 J-series Services Routers provide IP routing, WAN and LAN connectivity, and management services. Available in several models, Services Routers typically connect small, branch, or regional offices to a central site, and link Internet service provider (ISP) net ...

2 „ What You Need to Know What You Need to Know J-Web Access The Web interface to the router—called the J-Web interface—is enabled by default. To configure a Services Router with the Web interface, you attach a PC or laptop to Ethernet management port 0 on the chassis. Ethernet management port 0 is the built-in Fast ...

„ 3 J-series Services Router Quick Start Installing and Connecting Power Before installing and connecting a Services Router, read “Safety Warnings Summary” on page 13. Then make sure you have the equipment listed in Table 1. Table 1: Equipment Required for Services Router Installation Installing a Services Router To inst ...

4 „ Installing and Connecting Power 4. Have one person grasp each side of the router, lift the router, and position it in the rack. 5. Have a second person install a mounting screw into each of the bracket holes that are aligned with the threaded holes in the rack. Connecting AC or DC Power to a Services Router Some Serv ...

„ 5 J-series Services Router Quick Start Basic Connection and Configuration with the J-Web Interface For J-Web access, you connect from your management PC or laptop to the Services Router through Ethernet management port 0. (For information about the J-Web interface, see “J-Web Basics” on page ...

6 „ Basic Connection and Configuration with the J-Web Interface 3. Adding Licenses with the J-Web Interface If you purchased one or more licenses, you received an envelope with instructions for obtaining license keys from the Web. To enable each license on the router, you must add the license key. You can add one or more ...

„ 7 J-series Services Router Quick Start 4. To configure additional interfaces: a. Under Quick Configuration, click Interfaces, and then click the interface you want to configure—for example, fe-0/0/1. b. On the Interfaces page, click Add to add a logical interface. IP addresses are configured on ...

8 „ Basic Connection and Configuration with the CLI Basic Connection and Configuration with the CLI For CLI access, you connect from your management PC or laptop to the Services Router through the console port. (For information about the CLI, see “JUNOS CLI Basics” on page 11.) 1. Connecting, Logging In, and Starting ...

„ 9 J-series Services Router Quick Start 2. Updating the JUNOS Software with the CLI After starting up the Services Router, you might want to download the latest version of the JUNOS software from the Juniper Networks Web site and load it onto the router. You can use the CLI, but we recommend the J-Web interfa ...

10 „ J-Web Basics The unit number is the logical interface number. IP addresses are configured on the logical interface. Setting the protocol family to inet specifies the routing table of IPv4 addresses. 3. Set a default route (default gateway) for IPv4 packets. For example: root# set routing-options static route 0.0.0.0 ...