Lantronix FOX3-2G Application Note

into FOX3-2G/3G/4G Series Part Number APP-0009 Revision A October 2019 ...

2 Intellectual Property © 2019 Lantronix, Inc. All rights reserved. No part of the contents of this publication may be transmitted or reproduced in any form or by any means without the written permission of Lantronix. Lantronix is a registered trademark of Lantronix, Inc. in the United Stat ...

3 Revision History Date Rev. Comments August 2017 1.0.0 Initial version. December 2018 2.0.0 Implemented events related to the CPC TTM (Truck tire module “Sensor inside the tire”) data – See chapter 2.4 Implemented dynamic variables related to the CPC TTM (Truck tire module “Sensor in ...

4 Table of Contents 1. General .................................................................................................. 5 1.1 Information about this installation guide ......................................................... 5 1.2 What is ContiPressureCheckTM System ? ............. ...

5 1. GENERAL 1.1 Information about this installation guide This guide provides information on how to configure a FOX3-2G/3G/4G series device, connect to an in-vehicle installed ContiPressureCheckTM System(CPC-System) via FMS Gateway, read the data from this system and transfer them to your pl ...

6 1.4 Hardware Requirements • A vehicle with an integrated ContiPressureCheck™ system for trucks/tractors • FOX3-2G series devices with CAN-INTERFACE*, CPC* and firmware 2.16.0 or higher • FOX3-3G/4G series with CAN-INTERFACE*, CPC* and firmware 3.1.0 or higher • A SIM card with dat ...

7 2. READING DATA FROM THE CPC VIA THE FMS GATEWAYFOX3- 2G/3G/4G device configuration settings To read the data from a CPC system via the FMS gateway, you have to first configure your FOX3- 2G/3G/4G device by sending/saving the following PFAL script into the FOX3 series device with Workbench ...

8 More device configuration examples: $PFAL,cnf.set,AL6=SYS.eJ1939.TIRE_CPC_STAT_HEALTH>=0: TCP.Client.Send,8,"CONTI_Helth (J1939.TIRE_CPC_STAT_HEALTH)" $PFAL,cnf.set,AL7=SYS.eJ1939.TIRE_CPC_STAT_WEX>=0:TCP.Client.Send,8,"CONTI_WEX &(J1939.TIRE_CPC_STAT_WEX)" $PFAL,cnf.set,AL8=SYS.eJ1939.TIRE ...

9 2.3 Tire identification diagram This tire identification diagram shows the wheel position of a 3-axle truck/tractor and a 3-axle trailer. The wheel position is numbered as follow: 00 – Front left 01 - Front right 10 – 2nd axle left outer 11 - 2nd axle left inner 12 – 2nd axle right in ...

10 Example: SYS.eJ1939.TIRE_HEALTH>=0 SYS.eJ1939.TIRE_CPC_STAT_WEX This event is generated whenever the contents of the SYS.eJ1939.TIRE_CPC_STAT_WEX variable changes. Compares the contents of this variable with the used specified one and return a Boolean (True/False) repre ...