Nortek e Series Field Manual

i Contents Field Guide.................................................................................................................... 1 Disclaimer! ..................................................................................................................................1 Panel Wiring......... ...

Z-Wave Programming................................................................................................ 51 908.42 MHz (North America)...................................................................................................... 51 Z-Wave Hops.......................................... ...

iii Z-Wave Devices (908 MHz).......................................................................................................92 Home Automation – Electrical.................................................................................................... 92 Z-Wave Single Wall Outlet............. ...

1 Field Guide Disclaimer! This Field Guide contains programming information for the following panels: Legacy GC2 GC2e Legacy GC3 GC3e Unless otherwise noted, anything that says GC2 in this manual also applies to GC2e. Additionally, anything that says GC3 in this manual also applies to GC3e unless otherwis ...

Legacy GC2 Wiring Diagram Legacy GC2 Terminal Block 8) Hardwire Zone 2 7) Hardwire Zone 1 6) External Bell (-) 5) External Bell (+) (6-12 VDC @ 120mA max) 4) Open Collector Output (16VDC @ 250mA max) 3) Ground 2) 14VDC Input (-) from Transformer negative (-) 1) 14VDC Input (+) from Transformer positive ...

3 GC2e Wiring Diagram GC2e Terminal Block HW Hardwire Zone B- External Bell (-) B+ External Bell (+) (6-12 VDC @ 120mA max) COM Ground V- 14VDC Input (-) from Transformer negative (-) V+ 14VDC Input (+) from Transformer positive (+) ...

GC3/GC3e Wiring Diagram GC3/GC3e Terminal Blocks 8) Ground 7) Hardwire Zone 2 6) Hardwire Zone 1 5) External Bell (-) 4) External Bell (+) (6-12 VDC @ 120mA max) 3) Ground 2) 14VDC Input (-) from Transformer negative (-) 1) 14VDC Input (+) from Transformer positive (+) 9) TX 10) RX 11) Open Collector1 1 ...

5 Basic Programming GC2 Programming The GC2 and GC2e share the same programming features and flow. Default Access Codes Default Installer Code = 1561 Default Customer Code = 1111 GC2 Installer Toolbox To access the Installer Toolbox: 1. Press the 2GIG logo located on the bottom right of the GC2 home scre ...

GC2: System Configuration To access System Configuration: 1. Press the 2GIG logo on the GC2 home screen. 2. Enter the Installer Code (default code = 1561). 3. Press System Configuration. The default question Q1: Select RF sensor # (01 to 48, 63-74) will display. 4. To navigate to a specific question ...