Lippert Components Levelegs Installation Operation & Maintenance

Table of Contents Installation 2-10 Leveler legs……………………………………………………….....……… 2 Controller………………………………………………………………........ 4 Dip-switch Configurations…………………………………………………. 5 Wire Harness Installation…………………� ...

LEVELER LEGS 1. Install direct drive levelers as close to the front bulkhead, and the rear levelers as close to the rear wheels as possible in a rectangular formation. If the levelers are installed unevenly, the effectiveness of the system will be compromised. ...

2. Position leveler vertically against frame so base of foot has 8-9" minimum ground clearance when RV is loaded to its maximum GVWR (NOTE: the clearance of a raw rail is different than the clearance of a fully completed unit). 3. For all Leveleg installations, refer to the diagram with the correct configuration. A. For 5K Direct Drive Landing LegsTM, ...

Dip Switch Configuration • In order to accommodate as many units as possible, there is a set of four small “dip switches” on the control board that must be configured. Refer to the following table and figure for the required configuration for your RV. NOTE: If any of the blank configurations are used (noted by “DEAD POSITION) in the table below ...

Controller Location 1. To optimize the effectiveness of the Controller, it should be mounted as close to the center of the RV as possible. There is an optimal zone and an acceptable zone to install the Controller as shown to the right. Any other place will compromise the operation of the Controller. 2. Install Controller in a clean, dry interior area ...

CONTROLLER WIRING All information below pertains to the diagram on the page 10 NOTE: Atwood recommends using the Plug n’ Play harness kit • If modifications to the harnesses must be made, please mimic the Atwood harnesses, and follow the guidelines provided by the manufacturer of the harness terminals. Be sure any wire crimps are strong enough as ...

control pad. Signal Wire Harness / Activation Switch NOTE: It is important for this harness to be plugged in after all other wires are installed. 1. Locate the activation switch next to the installed auto position control pad allowing clearance for both the controller and switch mounting surfaces. Provide a space with the dimensions shown in the figur ...

Leveler Power Connections • Use the 10 AWG connectors (red and yellow wire) to connect the leveler motors to the control Board. NOTE: Wires cannot run no longer than 20’ to the front, and no longer than 30’ to the rear. 1. Plug in the four harnesses into the power terminal on each of the corresponding leveler motors. 2. Run the four harnesses fr ...