Makita M1902 Technical Information

Specifications Standard equipment Continuous Rating (W) Voltage (V) Cycle (Hz) Input Output Max Output (W) 110 120 220 230 240 4.6 4.0 2.4 2.3 2.6 50/60 50/60 50/60 50/60 50/60 480 N/A 500 500 580 145 130 225 225 300 550 550 550 550 550 Current (A) Planer blade 82 (re-sharpenable blade or disposable blade) Blade ga ...

2 CAUTION ................................................................................................................................................. ...

Follow the instructions described below in advance before repairing: · Wear gloves. · In order to avoid wrong reassembly, draw or write down where and how the parts are assembled, and what are the parts. It is also recommended to have boxes ready to keep ...

5-1-1 Disassembling Fig. 5-1-1-1 [1] Loosen two M4x25 Pan head screws, and remove Belt cover. Fig. 5-1-1-2 [2] Cut the old Poly V-belt 4-241 with cutting pliers. [3] When you use Poly V-belt 4-241 again, pry it off with a screwdriver while turning either of two V pulleys. Then, Poly V-belt 4-241 can be removed. Belt cover M4x25 ...

pulleys. Note: · All V-shaped ribs of Poly V-belt 4-241 must be engaged with the grooves of the both of V pulley. · Be careful not to push Poly V-belt 4-241 so deep that it rubs against Bracket complete. ...

Fig. 5-2-1-2 [3] Loosen M4x22 + Pan head screw, and remove Chip cover. Fig. 5-2-1-1 [2] Loosen six M6x17 Hex socket hex bolts by turning them counterclockwise with 1R016 and an impact driver, and remove two 82mm HSS Planer blades and two Drum plates. 1R016 Impact driver M6x1 ...

4x18 Tapping screw (6 pcs.) Fig. 5-2-1-5 [6] Tap Main frame complete with a plastic hammer, and remove the unit of Armature, Drum and Bracket complete. Main frame complete Drum Armature Bracket complete 7 / 19 ...

Fig. 5-2-1-7 [8] Remove Armature from Bracket complete with 1R045. 1R045 Bracket complete Armature 1R269 Ball bearing 6000DDW Ball bearing 607ZZ Fig. 5-2-1-6 [7] Hold Armature with a waste cloth, and remove V pulley 4-20L from Bracket complete by turning it clockwise with a bit a ...

Fig. 5-2-2-3 [5] Hold Armature with a waste cloth, and fasten moderately V pulley 4-20L to Bracket complete by turning it counterclockwise with a bit adapter assembly, double ended phillips bit and impact driver. Fig. 5-2-2-1 [2] Set the following parts in the order from the bottom: (1) ...

Bracket complete to Main frame complete. Note: Be careful not to lose Assist fan guide. Main frame complete Bracket complete Assist fan guide Armature Drum Fig. 5-2-2-5 [7] Tighten six M6x17 Hex socket hex bolts to 6 to 9N·m from the V pulley 4-37 side with 1R219, 1R220 and Socket 9. 1R220 1R219 Socke ...